HQ-Power AERON 575 I Manual Del Usuario página 6

a. DMX512 Connection
Connect an XLR cable to the female 3-pin XLR output of your controller and the other side to the male 3-pin XLR
input of the VDP575SC8M2. Multiple VDP575SC8M2s can be linked through serial linking. The linking cable should
be a two-core screened cable with XLR input and output connectors.
b. Occupation of the XLR Connection
c. DMX512 Chain with Termination
d. Control Panel and LCD Menu
Switch the device on and off by connecting it with the mains using the power plug.
• No DMX signal (2 running modes)
Sound-controlled mode. To select this function, disconnect the DMX signal, press the encoder
Sound
and turn it in an anti-clockwise direction. Press again to confirm.
Automatic program mode. To select this function, disconnect the DMX signal, press the encoder
Auto
and turn it in an anti-clockwise direction. Press again to confirm.
• DMX address
Addr To set the DMX address, press the encoder and turn it in a clockwise direction to increase the
001 value or in an anti-clockwise direction to decrease the value. Press again to confirm.
• Pan/tilt reverse
Reverse tilt Y Reverse tilt. Press the encoder and turn it in an anti-clockwise direction. Press again to confirm.
Reverse tilt N Normal tilt. Press the encoder and turn it in a clockwise direction. Press again to confirm.
Reverse pan. Press the encoder and turn it in an anti-clockwise direction. Press again to
Reverse pan Y
confirm.
Reverse pan N Normal pan. Press the encoder and turn it in a clockwise direction. Press again to confirm.
• Chase speed
To set the chase speed, press the encoder and turn it in a clockwise direction to increase the
Chase
value (faster) or in an anti-clockwise direction to decrease the value (slower). Press again to
Speed001
confirm.
VDP575SC8M2
A DMX terminator is recommended for installations where the DMX cable has to run a
long distance or is in an electrically noisy environment (e.g. discos). The terminator
prevents corruption of the digital control signal by electrical noise. The DMX terminator is
simply an XLR plug with a 120 resistor between pins 2 and 3, which is then plugged into
the XLR output socket of the last device in the chain.
Please see illustrations.
1. ground
2. signal -
3. signal +
6 HQPOWER