Grounding The Generator; Starting The Engine - Briggs & Stratton GENERAC PowerBOSS Storm-Plus 5500 El Manual Del Propietario

GROUNDING THE
GENERATOR
The National Electrical Code requires that the frame and
external electrically conductive parts of this generator be
properly connected to an approved earth ground. Local
electrical codes may also require proper grounding of the
unit. For that purpose, a GROUNDING WING NUT is
provided on the generator end (Figure 3).
Figure 3 — Grounding Wing Nut
Grounding
Wing Nut
Generally, connecting a No. 12 AWG (American Wire
Gauge) stranded copper wire to the grounding wing nut
and to an earth–driven copper or brass grounding rod
(electrode) provides adequate protection against electrical
shock. Be careful to keep the grounding wire attached after
connecting the stranded copper wire. However, local codes
may vary widely. Consult with a local electrician for
grounding requirements in your area.
Properly grounding the generator helps prevent electrical
shock if a ground fault condition exists in the generator or
in connected electrical devices, especially when the unit is
equipped with a wheel kit. Proper grounding also helps
dissipate static electricity, which often builds up in
ungrounded devices.
PowerBoss 5,500 Watt Storm-Plus Generator
OPERATING THE
GENERATOR
CAUTION!
with electrical loads connected to the receptacles
AND with the connected devices turned ON.

Starting the Engine

Disconnect all electrical loads from the generator. Use the
following start instruction steps by numerical order:
1. Turn the fuel valve to the "On" position (Figure 4).
Figure 4 — Fuel Valve
Fuel Valve is shown
in the On position
2. Place the choke lever in the "Choke" position
(Figure 5).
Figure 5 — Choke Lever
7
NEVER start or stop the engine