Stalgast TG-1 Serie Manual De Instrucciones página 41

protected in an evenly distributed manner - not less than 30 cm
• from an unprotected flammable wall, i.e. a wall made of wood or other flammable materials
- not less than 60 cm
• Appliances adapted for combustion of LPG must not be installed below the grade level (e.g. basements).
• The temperature of rooms of cylinder installation shall not exceed 35
with adjustable feet as shown in Fig. 14 (adjustment range - from -20 to 40 mm).
a. In the case of appliances connected to the LPG cylinder:
• Cylinders shall be located at least 1.5 m from heat-radiating devices (heaters, furnaces, etc.), except for
those with cylinder cabinets.
• Attention: If the appliance has a gas cylinder compartment, this compartment should be designed as to
contain only one gas cylinder having a maximum capacity of 20 kg.
• In this case (gas appliance with the cylinder placed in the cabinet) the total heat load of the appliance should
not exceed 12 kW.
• Do not place cylinders in the vicinity of any other sparking appliances.
• Place the cylinders upright and protect them against impact, overturning or accidental moving.
• The liquid gas stove should be connected to the hose (LPG hose bearing „B" safety mark) by means of a
seamless steel pipe at least 50 cm long.
• The hose must be protected with wire ties at both ends to prevent it from sliding. The length of the hose
must not be less than 1.2 m and not higher than 3.0 m.
• LPG cylinder should be equipped with a gas pressure regulator. The pressure at the outlet from the pressu-
re regulator should correspond to the pressure on the nameplate
b. In the case of appliances connected to a natural gas installation:
• Natural-gas stoves (2E; 2H; 2LW; 2L) should be connected to the gas system inside the building as fixed
connection or with flexible metal hoses bearing the valid safety mark. The stove has a gas connection with
an R ½" thread (Fig.15 item 1).
1
2
Gas stool cooker
c. Adaptation of the appliance to another type of gas should be performed by an authorized
fitter. It involves the following:
• Nozzle replacement in gas burners - nozzle diameters for the respective gas are given in the tables under
the heading „Characteristics of burners"
Figure 14. Levelling the unit
Freestanding gas cooker
Figure 15. Rear view to the unit.
- 41 -
o
C. The kitchen should be leveled
1.
Gas connection
2. Nameplate