Interchange NSR83-21SPS Manual Del Operador página 8

NSR83-21SPS
8
OPERATINg ThE NAILER
1
Switch
2
3
Switch
4
ƒ Use INTERCHANGE pneumatic tool lubricant. Do
ƒ Filter-regulator-lubricator units should always be
ƒ If a lubricator is not available, supply 3 to 5 drops of
Interchange Brands Framing Nailers: Operator's Manual
METhODS Of OPERATION
Single fire
1
ƒ The switch is in the upward position as shown in
the illustration at the left.
2
ƒ Depress the contact arm against the work surface
and pull the trigger. Tool cannot fire a second nail
until the trigger is released and tool can cycle.
Bump fire (Multi-fire) *
3
ƒ The switch is in the downward position as shown in
the illustration at the left.
4
ƒ Hold the trigger and depress the contact arm
against the work surface.
*Caution: do not carry tool with trigger
depressed. This could result in accidental
firing of the tool.
LUBRICATION
It is important that the tool be properly lubricated.
Without proper lubrication, the tool will not work
properly and parts will wear prematurely.
not use detergent oil or additives. These lubricants
will harm the O-rings and other rubber parts. This will
cause the tool to malfunction.
used. Keep the lubricator filled with INTERCHANGE
pneumatic tool lubricant.
INTERCHANGE pneumatic tool lubricant into the air
plug on the tool twice a day.