Installing The Infant Restraint And Base Using Vehicle Belt - Graco PD117207B Manual Del Propietário

3. Buckle the vehicle belt. Make sure the buckle
tongue goes into the correct buckle – . The seat
belt should not be twisted or turned.
4. Tighten the vehicle seat belt. Refer to your
vehicle ownerÊs manual and the instructions in „6.2.2 SAFE Vehicle
Belt Systems‰ , page 29-31, on tightening your vehicle belt when
using the infant restraint without base.
To create a secure installation, push down
hard with your free hand on the infant
restraint — and pull and tighten the
vehicle belt.
5. Test infant restraint for secure installation
as described in infant restraint „Final Safety
Check‰ page 40 .
7.2 Installing the Infant Restraint and Base
Using Vehicle Belt
When using the base to install the infant
restraint, the lock-off is ALWAYS used to
secure both belts of the lap or lap/shoulder
belt.
1. Place the base in a rear-facing position
on a vehicle seat.
2. Open the lock-off and route the vehicle
belt through the belt path and over the
lock-off. ˜
34
—
Lock-off
–
˜