Placement Tool; Electrical Connection - stayer PBL122BK Manual De Instrucciones

gb
Power tools PBL122BK are designed for tightening
and loosening screws, for drilling in wood, metal,
ceramic and plastic, and impact drilling in brick,
concrete and stone.
1_SPECIFIC SAFETY INSTRUCTIONS
Hold power tool by insulated gripping surfaces,
when performing an operation where the fastener
may contact hidden wiring. Fasteners contacting
a "live" wire may make exposed metal parts of the
power tool "live" and could give the operator an
electric shock.
Secure the workpiece. A workpiece clamped with
clamping devices or in a vice is held more secure than
by hand.
Always wait until the machine has come to a
complete stop before placing it down. The tool insert
can jam and lead to loss of control over the power
tool.
Do not open the battery. Danger of short-circuiting.
Protect the battery against heat, e. g.,
against continuous intense sunlight, fire,
water, and moisture. Danger of explosion.
In case of damage and improper use of the battery,
vapours may be emitted. Provide for fresh air
and seek medical help in case of complaints. The
vapours can irritate the respiratory system.
Use the battery only in conjunction with your
STAYER power tool. This measure alone protects the
battery against dangerous overload.
Use only original STAYER batteries with the voltage
listed on the nameplate of your power tool. When
using other batteries, e. g. imitations, reconditioned
batteries or other brands, there is danger of injury as
well as property damage through exploding batteries.
2_INSTRUCTIONS FOR USE

PLACEMENT TOOL

Read all safety warnings and all instructions.
Failure to follow the warnings andinstructions
may result in electric shock, fire and/or
serious injury.
ASSEMBLY
Do not continue to press the On/Off switch
after the machine has been automatically
switched off.
- The battery can be damaged..
To remove the battery 5 press the unlocking buttonsv
9 and pull out the battery downwards. Do not exert
any force.
The battery is equipped with a temperature control
which allows charging only within a temperature
range of between 0 °C and 45 °C. A long battery
service life is achieved in this manner.
Observe the notes for disposal.

ELECTRICAL CONNECTION

Battery Charging
Use only the battery chargers listed on the accessories
page. Only these battery chargers are matched to the
lithium ion battery of your power tool.
The battery is supplied partially charged. To
ensure full capacity of the battery, completely
charge the battery in the battery charger
before using your power tool for the first
time.
The lithium-ion battery can be charged at any time
without reducing its service life. Interrupting the
charging procedure does not damage the battery.
The lithium-ion battery is protected against deep
discharging. When the battery is empty, the machine is
switched off by means of a protective circuit: The inserted
tool no longer rotates.
Charge status indicator
The charging status indicator 10 of the magazine, is
composed of two LEDs:
Green: Displayed when the battery is charged.
Red: Displayed when the battery is charging.
Temperature Dependent Overload Protection
When using as intended for, the power tool cannot
be subject to overload. When the load is too high or
the allowable battery temperature range of 0–50 °C
is exceeded, the speed is reduced. The power tool
will not run at full speed until reaching the allowable
battery temperature.
ILUSTRATED DESCRIPTION
1 Screwdriver bit
2 Tool holder
3 Ring preset torque setting for
4 Speed selector
5 Battery
6 Bulb
7 On/Off switch
8 Rotational direction switch
9 Battery unlocking button
10 Battery charge-control indicator
11 Charger
/ /
12