Idiomas disponibles
Idiomas disponibles
8. Tighten the setscrew to firmly contact the nut. Back off the
setscrew ¼ turn (approx.) note: DO NOT leave the setscrew
tightened firmly to the nut as this may cause improper operation.
The movable jaw is designed to move slightly (pivot side to side)
so maximum jaw plate contact is maintained when clamping out-
of-parallel, sawed, or cast parts.
9. Your vise is now ready for use. Open and close your vise to check
for proper operation. Center the part to be clamped in the vise and
close. Your parts should be centered from side to side to insure
proper clamping. (See Fig. 5 below)
Fig.5
Stationary Jaw
17
ENGLISH |
Segment (Half Moon)
Screw
Socket Head Set Screw
Screw brush seals
Maintenance Schedule
Capítulos
