Putting Your Pump Together - Tommee Tippee Made for Me Manual Del Usuario

Putting your pump together

Each time you use your breast pump,
check all parts of the pump and
power unit for any damage.
Wash your hands with soap and
water and dry thoroughly before
handling your breast pump.
Make sure that all parts of the pump
have been washed, cleaned and
sterilized, and are completely dry.
1. Place the clear diaphragm
1
1
in the top of the body and
push down gently to get a
good seal.
2. Place the clear diaphragm
2
cap over the diaphragm
and push down gently
to seal.
3. Place the purple lid over the
3
top of the body and turn
it clockwise until it clicks
closed.
4. Push the soft, silicone cup
4
into the widest part of the
horn and smooth its lip
evenly over the edge.
Work your way all around
the rim to make sure the cup
fits smoothly, evenly and
securely. The two dimples in
the cup should be clear to
allow air into the horn.
5 5. Now smooth the lip of the
silicone cup around the
narrow end of the horn in
the same way.
Once you've fitted and used it, you don't have to
take the silicone cup out of the horn unless milk or
dirt becomes trapped inside. Then you can ease
the edges of the cup from the horn and gently pull
them apart for cleaning.
6 6. Push the horn with cup
attached onto the body
until it's fully engaged and
secure. Turn your pump
handset upside down.
7. Insert the purple
7
duck-bill valve. Gently
squeeze the sides of the
valve to make sure it's
open.
8. Screw in a Tommee
8
Tippee Closer to Nature
or Advanced Anti-Colic
bottle. This breast pump is
designed to fit all Tommee
Tippee Closer to Nature
and Advanced Anti-Colic
bottles and Pump & Go milk
pouches with adaptor rings
(excludes Tommee Tippee
Closer to Nature glass
bottles).
9. Repeat for the other breast
pump handset.
10. Place the assembled pumps on
10
a flat surface. Connect one end
of the air tube to the purple lid
of each pump body and the
other to the power unit. The air
tubes go into the two holes at
the front of the unit.
11. Insert the other end of the air
11
SINGLE
tubes into both sockets on
the front of the power unit. If
you want to use the pump in
single mode only insert the
air tube into the single socket
DOUBLE
marked .
4