Charging The Batteries; Replacing The Batteries - Portfolio SS13P-P2-BK-CPK3 Manual Del Usuario

3. Connect one light to another with the pre-attached
male and female connectors. Connect light string
to the power outlet at the back of solar panel.
Push the assembly flood light and solar panel into
the ground.
Note: Do not use a hammer.
CARE AND CARE CARE CARE AND AND AND MAINTENANCE MAINTENANCE MAINTENANCE MAINTENANCE

• CHARGING THE BATTERIES

For optimum performance, it is best to install the solar light in full sunlight and charge for 10 - 12
hours. Allow the light to run at least 8 - 12 complete charging and discharging cycles to reach the
batteries' maximum capacity.

• REPLACING THE BATTERIES

The included rechargeable batteries will usually last two years. Replace batteries only when you
notice the performance of your solar light is weaker than its normal operation in the first year.
Remove the battery compartment cover and replace the old
batteries with new 18500 lithium phosphate rechargeable
batteries. A minimum capacity of
Replace the battery compartment cover and lens. (FIG.1)
CAUTION: CAUTION: CAUTION: CAUTION:
BATTERIES MUST BE RECYCLED OR DISPOSED OF
PROPERLY.
NOTE :Do not mix old and new batteries.
Do not mix alkaline, standard (carbon zinc), or rechargeable (nicad, nimh, etc) batteries.
Caution for ingestion.
• WINTER TIPS
Keep debris and snow off the solar panel to allow the batteries to recharge. If lights have been
covered by snow for a long time, allow batteries to recharge in full, direct sunlight for at least
10 - 12 hours so that they maintain maximum capacity.
3 3 3 3
600mAh is required.
4
1 1 1 1