Connecting The Printer To Your Computer; Installing The Software - Dymo Rhino 6000 Guia De Inicio Rapido

4. Connecting the printer to your computer

Your printer connects to your computer using the USB connection located on the
top of the printer.
Do not connect the printer to your computer until prompted to do so during
NOTE
the software installation.
To connect the printer to your computer
Plug the USB cable into the USB port on
1.
the bottom of the printer. See Figure 5.
Plug the USB cable into a USB port
2.
ONLY when prompted during the
software installation.

5. Installing the Software

To install the software
Insert the RHINO Connect Software CD into your CD-ROM drive. After a
1.
few seconds, the installation screen appears. If the installation screen does
not appear:
Click Start and then Run on the Windows taskbar. The Run dialog
a.
box appears.
Enter D:\setup.exe (where D is the CD-ROM drive letter) and click OK.
b.
Follow the on-screen instructions.
2.
When prompted by the installer, plug the USB cable into a USB port.
3.
4
Figure 5