König Electronic KN-MICW330 Manual página 6

All manuals and user guides at all-guides.com
Set up:
1. Check that the voltage of the supplied AC adapter conforms to the voltage available
in your local area. Using the wrong AC adapter may cause irrepairable damage to the
unit.
2. Plug the feeder cable of the supplied AC adapter into the DC IN socket on the receiver.
Then plug the AC adapter into a power outlet.
3. Connect the connection cable to an amplifier or audio mixer. In order to make sure the
sound quality is good and avoid distortion, please adjust the volume level according to
the following instructions:
When using an connection cable with 3-pin XLR connector or
6.35mm plug to connect to the MIC IN on the audio mixer or on the
amplifier, please turn the Volume Level Control of the receiver to
the 1 o'clock position, the output level for balanced and unbalanced
output is around 77mV.
MIN MAX
V OLUME
When using a connection cable with 3-pin XLR connectors or
6.35mm phone plugs to connect to the LINE IN on the audio mixer or
on the amplifier, please turn the Volume Level Control of the receiver
to the MAX. position, the output level for balanced and unbalanced
output is around 770mV.
MIN MAX
V OLUME
Never use the balanced and unbalanced audio outputs at the same time! This may cause
signal loss or increased noise.
Note:
Prior to setting up, please check that the transmitter and receiver are tuned to the same
frequency. Two or more transmitters operating on the same frequency can not be used at
the same time. So for each extra transmitter, please select a different frequency which
can be used simultaneously.
Manual setting:
1. Setting an interference-free channel by manual tuning
Press for 4 seconds to turn on the power.
2.
Press and hold down the button  or  until "MANUAL"
mode is selected.
6