Adjusting The Harness Height - BQS BTG 0123 Manual De Uso

3.1. Adjusting the harness height

In order to fit the harness to the child's height:
1. Loosen the harness straps by pulling them gently while pressing the harness
adjustment button
2. Loosen the harness straps from the back of the seat, freeing them from the
harness connector
3. Pull the harness straps from the front to free them from the seat back.
4. Reinsert the harness straps in the slot
5. Reinsert the harness straps in the connector on the back of the seat.
6. Ensure the straps are not twisted at any point.
3.2. Installing the child seat rearward facing. Group 0+
1. Recline the seat fully. Pull the lever
to position 4 without releasing the lever. Release the lever when the seat is in
the desired position (fig. 3.4 and 3.5).
2. Turn the seat over and unfold the group 0+ height adjuster device
3. Place the seat in the back seat of the vehicle in opposite direction of travel.
4. Pass the abdominal strap of the car belt through the lower seat guides
(fig.3.7 and 3.8) and underneath the seat. Buckle the vehicle seat belt until you
hear a click (fig. 3.9).
5. Pass the diagonal section of the seat belt through the upper guide
shown in fig. 3.9.
6. Take up the remaining slack of the diagonal section of the 3-point seat belt and
make sure it is as tight fitting as possible. Ensure the straps are not twisted or
knotted at any point (fig. 3.10).
4. INSTALLING THE CHILD SEAT REARWARD FACING. GROUP 1
NOTICE
A correctly adjusted headrest ensures optimal protection for the child in the safety
seat. The headrest should be adjusted so that the shoulder straps are at the same
height as the child's shoulders (fig. 3.1).
1. Recline the seat fully. Pull the lever
to position 4 without releasing the lever. Release the lever when the seat is in
the desired position (fig. 3.4 and 3.5).
30
(I)
(fig. 4.1).
(N)
(fig. 3.2 and 3.3).
(G)
GROUP 1 only.
From 9 months to 4 years approx. (9 - 18 kg)
(G)
(L)
at the desired height.
forward and adjust the angle of recline
forward and adjust the angle of recline
(Q)
(fig.3.6).
(F)
(K)
as
BTG 0123