Tool Preparation - BGS technic 8708 Manual Del Usuario

TOOL PREPARATION

Insert pressure bolts (3) with the O-ring side
into the bores (C)
of the pressure plate (2).
Install the thrust piece (7) with the bored side
towards the spindle nut (8),
onto the spindle (1).
B
A= Will be mounted from the rear
towards the wheel bearing housing
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
3
2
Disassembly
A
Tel.: 02196 720480
Fax.: 02196 7204820
[email protected]
Push the bearing pressure ring (10), with small
side (D) towards the bearing (E) onto the
C
Install the pressure piece (6) on the spindle (1).
Attention: Pressing piece (6) can be installed on
both sides, depending on the bearing.
B
B= Will be mounted from the front
towards the wheel bearing housing
spindle (1).
1
10
D
E
2
Assembly
A
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed