Battery Installation - Hobbytech NXT SPIRIT EP 2.0 Manual De Instrucciones

EVEN IF THIS CAR IS A READY TO RUN KIT, YOU STILL HAVE SOME LITTLE THINGS TO DO TO FAMILIARI ZE WITH YOUR
PRODUCT. PLEASE FOLLOW THESE STEPS.
For obvious reasons of security, the KONECT KT3S+NEO radio system is equipped with an automatic power shut
down of the receiver when the user turns the transmitter On while turning the steering wheel or touching the
throttle trigger.
Consequently on ignition, the vehicle won't (for example) unintentionally accelerate. The transmitter Led flashes
red, and the user cannot use it anymore. Then it must be turned Off and On without touching anything else.
Functions
KT3S+NEO Transmitter
Steering Wheel
Throttle Trigger
Battery Compartment Tray
Antenna
Power ON / OFF
SYNC & Battery Indicator
Switch: Every impulse controls CH3
ATV
ST. Trim Dial
TH. Trim Dial
BIND: Pairing
EPA
WARNING: accidental or intentional EPA function manipulation may
cause servos malfunction (reduced or inexistant travel). Please
reset maximum default values before contacting your dealer
(see ).
5

Battery Installation

Works with 4 x 1.5V AA
Batteries (not provided),
KT3S+NEO can be operated
a few hours. Installation:
Remove the battery
compartment cover as
shown below.
Warning: Never disassemble batteries or put the batteries in fire, chemical
agents, otherwise they may cause personal injuries or property damages.
Battery Disposal: Observe corresponding regulations about wasted battery
treatment regulations.
1. After running out of power, dispose of wasted batteries in designated areas
far away from water supply, household areas and planted areas.
2. Submit the wasted batteries to specific recycling stations.
6
TRANSMITTER
: Control direction (Left / Right) of the RC model
: Control speed and direction
(Forward/Brake/Backward) of the driving
model.
:
Cover and hold the batteries powering the
transmitter.
: Transmit signal to the model
: Power ON / OFF the transmitter
: Top Green LED light indicates
synchronization status
and/or adequate battery power supply.
: Adjustable Steering Rate by ATV dial
: Adjust the neutral position of steering servo
when model wheels are straight ahead.
: Make sure the model stays still when
releasing the throttle trigger.
:
End Point Adjustment
Install the batteries Then reicompart-
observing the polarity ment cover as the
marked on battery picture shown
compartment. below.
ATV
Switch
Power Indicator
Power
ON / OFF
Steering
Reverse Switch
Throttle
Reverse Switch
Steering Trim Dial
Throttle Trim Dial
Battery
Compartment Tray
Battery LED Indicator
- During normal operation, the LED should be solid green
- When battery voltage is dropped below 3.8V, the LED will become red color,
to indicate battery is low, you should replace new battery as soon as possible
Pre-Run Check
LED
LED
Indicator indicator
* Always turn on the transmitter first by sliding the switch on the left side from
bottom to top. The green lights above the switch should light up. If not, you
need to check for low or incorrectly installed batteries.
Antenna
Steering Wheel
Throttle Trigger
BIND / EPA Key
ON-
1. Steering : Adjust the steering trim to
keep the front wheels in straight line when
steering wheel remains in NEUTRAL
position.
2. Throttle : Adjust the throttle trim to
ensure the wheels stop rotating when
throttle trigger remains in NEUTRAL
position (only for nitro).
For EP vehicles, this button must be
set to NEUTRAL (calibrate the NEUTRAL
with ESC).