Air Filter - Inspection And Replacement; Belt - Replacement - Craftsman 919.184193 Manual Del Propietário

Ocultar thumbs Ver también para 919.184193:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Risk of property
damage. Overfilling
with oil will cause premature
compressor failure. Do not overfill.
5.
Replace oil fill plug (A) and tighten
securely.
AIR FILTER - INSPECTION AND
REPLACEMENT
Hot surfaces.
Risk of burn.
Compressor heads are exposed
when filter cover is removed.
Allow compressor to cool prior to
servicing.
Risk of property
damage. Keep the air
filter clean at all times. Do not operate
the air compressor with the air filter
removed.
A dirty air filter will not allow the com-
pressor to operate at full capacity.
Keep the air filter clean at all times.
1.
Remove the air filter cover.
2.
Remove the air filter from filter
cover.
IMPORTANT: Do not operate the
compressor with the air filter removed.
3.
Place new air filter into filter cover.
Refer to the Repair Parts for the
correct part number.
4.
Replace air filter cover and lock
into place.

BELT - REPLACEMENT

Risk of personal
injury. Serious
injury or damage may occur if
parts of the body or loose items
get caught in moving parts. Never
operate the outfit with the belt
guard removed. The belt guard
should be removed only when
the air compressor power is
disconnected.
1.
Turn air compressor off, lock out
the power supply, and relieve all
air pressure from the air tank.
2.
Remove the front of the belt
guard by disengaging the snaps.
Insert a flat bladed screwdriver at
each snap location and pry the
beltguard apart.
All manuals and user guides at all-guides.com
3.
Loosen the wing nut on hold
down plate and tilt motor to allow
for easy removal or installation of
the belt.
4.
Remove belt.
Risk of moving
parts. Use caution
when rolling belt onto flywheel,
fingers can get caught between the
belt and flywheel.
Replace belt. NOTE: The belt
5.
must be centered over the
grooves on the flywheel and
motor pulley.
Wing Nut
6.
Turn the wing nut on the hold
down plate until it makes contact
with the washer, plus one
additional turn.
7.
Replace the belt guard
18-ENG
Belt Guard
.

Capítulos

Tabla de contenido
loading

Tabla de contenido