JAROLIFT TDRC08 Instrucciones Originales página 17

Individual service
Select the desired channel or motor with the help of the K1 and K3 keys (key description see page 5).
Briefly press the UP, STOP or DOWN key to control the operating state of the motor.
Active channel via
K1 or K3 Select.
Setting the group control
1. First press the K2 button on the handheld transmitter for two seconds to activate the group control mode. The selected
channel now flashes in the upper left corner of the display.
2. Now you can select the desired channels with the K1 and K3 keys. By briefly pressing the K2 key, you can add the active
channel (marked with a square in the display) to the group. Proceed in the same way for each additional channel to be added
to the group.
3. To remove a channel from the group again, select the channel to be deleted with K1 and K3 and then briefly press the K2
key.
4. When you are satisfied with your setting, press the UP, STOP or DOWN button to exit the group assign-
ment. You can now control the created group using the operating keys
K2 key for 2 se-
conds press.
The selected function is indicated in the display by the symbols S
(individual control) and M (group control).
You can switch between the settings by briefly pressing the K2 key.
Via UP, DOWN and
STOP button to
control the motor.
Select the desired
channels select
with K3 and add
them via K2 add.
PROGRAMMING
Exit the Group
assignment via UP
/ STOP- / or DOWN
key.
Multi Single
(group control) (single control)
M S
1 2 3 4 5 6 7 8
Channels
17