Cool/Fan Only Mode; Dehumidification Mode - Hiyasu ASE1297T12i Manual De Funcionamiento

Manual 06-05ENG 6/5/05 17:27

Cool/fan only mode

Dehumidification mode

84
Página 84
MODES
1. Mode selection button (MODE)
2. Temperature button(TEMP.)
3. Botón de velocidad del ventilador (FAN)
4. On/off button
●
1. Mode selection button (MODE)
2. Temperature button (TEMP.)
3. On/off button
Switching on
Connect the unit to the electricity supply.
The OPERATION pilot on the viewer panel on the
interior unit will start to flash.
Select COOL, HEAT (not for COOL ONLY units) or
FAN ONLY.
Set the required temperature.
Cool: 21ºC or higher.
Heat: 28ºC or lower.
Seleccione "AUTO", "LOW", "MED" o "HIGH".
Press this button to switch on the air conditioner.
The OPERATION panel on the viewers on the inte-
rior unit will light up. The operating mode will be
selected according to the room temperature. The
device will start to function approximately 3 minu-
tes later. (If you select FAN ONLY mode, the unit will
start up immediately).
Swittching off
ON/OFF button
To switch off the air conditioner, press this button
again.
FAN ONLY mode does not control the temperature.
Therefore, follow only steps 1, 3 and 4 to select this
mode.
Switching on
Connect the unit to the electricity supply.
The OPERATION pilot on the viewer panel on the
interior unit will start to flash.
Select DRY.
Press the "TEMP" button.
The fan speed indicator will display AUTO. The fan
speed selected automatically will be LOW.
Press this button to switch on the air conditioner.
The OPERATION pilot on the viewer panel on the
interior unit will light up and the unit will start to
function after approximately 3 minutes.
Switching off
ON/OFF button
To switch off the air conditioner, press this button
again.