Function Settings - BGS technic 70210 Manual Del Usuario

BATTERIES
• Do not mix old and new batteries with this torque wrench.
Do not mix alkaline with carbon zinc or rechargeable lithium-ion (Li-ion) batteries.
•
•
Do not install batteries backwards.
Do not throw batteries into fire. Batteries can explode or leak causing personal injury.
•
Remove batteries when storing the torque wrench for a long period. Batteries should be stored
•
at room temperature.
NOTE
If the battery capacity is low, a battery symbol will be displayed on the screen to remind you to change
new batteries. If the wrench not in use for a period of time, remove the batteries from compartment.
The battery life is not only decide by its quality but also the last of acting flash, buzzer and backlight.
DESCRIPTION
1 LED
2
LCD
3 TRACE & PEAK
4 POWER
5 MEMORY
6 UNIT
7 BUZZER
8
BATTERY

FUNCTION SETTINGS

Battery
•
Install and change batteries: Open the end cap then insert two 1.5V AAA batteries (positive end
first) into compartment, tighten the cap.
Switch on/off the power
•
Press the power button
modes trace (trACE) & peak hold (PtoP) to use, when switch is done. The LCD will show one of
the mode and digit 00.0.Pr. LCD will display both torque unit and value.
Set Torque Unit Selection: kg/cm, kg/m, lb-in, lb-ft, N/m
•
Please press the button
• Set Torque Value.
Press the
memorized after flashing 10 seconds then LCD will show 00.0 automatically.
Peak Hold Operation
•
In this mode, an acoustic and optical signal is output when the previously set torque value is
reached. Press
press or
Track Mode Operation
•
In this mode, the display shows the currently applied torque.
Press &
torque.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
for 3 seconds will turn on the LCD screen and buzzer. There are two
& at the same time and release them to select different torque unit.
or button to apply a right value then release it to set up torque, the value will be
& at same time then release it to get (PtoP) peak hold set up mode, then
button to set up the torque.
in the same time again to get trace (trACE) mode then use
Tel.: 02196 720480
Fax.: 02196 7204820
[email protected]
or to to set up
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed