Idiomas disponibles
Idiomas disponibles
4. ELECTRICAL CONNECTION
a. Make sure your car battery is a 12 volt (6 filler caps) negative ground system (if not, a
converter will be necessary).
b. Before starting wiring connections, disconnect the power supply by removing the fuse from
the fuse box.
c. Connect the power wire to one of the extra terminals of the fuse box.
d. Connect the black ground wire to a metal part of the car. It is important to make good contact.
e. Make other wiring connections as shown.
f. If your car does not have ISO connector, you can procure it from any car accessory shop.
Notes: INCORRECT WIRING OR OPERATION WILL AVOID THE WARRANTY OF THIS UNIT .
(CAR UNIT BACK SIDE)
Fuse Replacement:
To replace the fuse, pull out the blown fuse
from the socket. Insert a new one with same rating
4 SPEAKER SYSTEM
RED
POWER(+)
12V+
YELLOW (FUSED)
MEMORY
BLACK
GND
GREEN
REAR
GREEN/BLACK
LEFT
WHITE
SP.
WHITE / BLACK
FRONT
Page 6
All manuals and user guides at all-guides.com
885A
885A
FUSE
ANTENNA CONNECTOR
LINE OUT 1
RED R
WHITE L
LINE OUT 2
RED R
WHITE L
AUX-IN
RED R
WHITE L
BLUE
AUTO ANT.
VIOLET
REAR
VIOLET/BLACK
RIGHT
GREY
SP.
GREY / BLACK
FRONT
5.GERNERAL OPERATION
POWER BUTTON
Press power button to turn on/off the unit.
MENU BUTTON
You can operate the following function through MENU button.
A. AUDIO OPERATION
press MENU button for less than 1 second to open the Audio menu.
press MENU repeatedly to navigate through the following functions:
VOLUME (VOL) -> BASS (BAS) -> TREBLE (TRE) -> BALANCE (BAL) -> FADER (FAD)
Rotate Volume Control to adjust desired level within 5 seconds.
NOTE: BASS AND TREBLE WILL BE SKIPPED IF DSP MODE IS ACTIVATED
B. OTHER OPERATION
press MENU button for more than 2 seconds to open another set of menu, press MENU
button repeatedly to navigate through the menu items, while the desired menu item is
displayed, use Volume control to adjust the selected function:
- DSP MODE (PRESET EQUALIZER)
POP -> ROCK -> CLASSIC -> FLAT -> DSP OFF
At DSP off mode preset equalizer will be controlled by Bass / Treble setting.
- ESP MODE (ELECTRONIC ANTI-SKIP PROTECTION)
You can select the second of ESP as follow
ESP 12 second: For normal road condition
ESP 45 second: For road conditon extremely UN-EVEN.
- BEEP MODE (BEEP ON / OFF)
BEEP OFF: disable audible beep tone when any function is accessed.
BEEP ON: enable audible beep tone.
- SEEK MODE (SEEK 1 / SEEK 2)
You can choose from Seek tuning mode 1 & mode 2 by using Volume Control.
While the desired Seek tuning mode is selected, the following operations can be
performed:
SEEK1: Press the Tuning Up / Down Button briefly to increase or decrease the frequency by 1
step size.
Press and hold the Tuning Up / Down button to seek the band in up or down direction
and stop when a station is received.
SEEK2: Press the Tuning Up / Down Button briefly to increase or decrease the frequency by 1 Step
size.
Press and hold the Tuning Up / Down button increase or decrease the frequency rapidly
until the button is released, the different between the same operation at SEEK 1 mode is
that this time the radio will not stop at any station.
Page 7
