Idiomas disponibles
Idiomas disponibles
1.HANDLING COMPACT DISCS
MOISTURE CONDENSATION
On a rainy day or in a very damp area, moisture may condense on the lenses inside the unit. Should this occur, the unit
will not operate properly. In such a case, remove the disc and wait for about an hour until the moisture has evaporated.
NOTES ON CDs
1.
A dirty or defective disc may cause sound
dropouts while playing. To enjoy optimum
sound, handle the disc as follows.
Handle the disc by its edge. To keep the
disc clean, do not touch the surface (P .1).
P . 1
2.
Do not stick paper or tape on the disc (P .2).
P . 2
Do not expose the discs to direct sunlight or
3.
heat sources such as hot air-ducts, or leave
them in a car parked in direct sunlight where
there can be a considerable rise in
temperature inside the car (P .3).
P . 3
4.
Before playing, clean the discs with an
optional cleaning cloth. Wipe each disc from
the centre out (P .4).
P . 4
5. Do not use solvents such as benzine,
thinner,commercially available cleaners, or
antistatic spray intended for analog discs.
Page 2
All manuals and user guides at all-guides.com
NOTES ON DISCS
If you use the discs explained below, the sticky residue can
cause the CD to stop spinning and may cause malfunction or
ruin your discs.
Do not use second-hand or rental CDs that have a sticky residue
on the surface (for example, from peeled-off stickers or from
ink, or glue leaking from under the stickers).
There are paste residue.
Ink is sticky (P .5).
****
*******
*******
******* *******
P . 5
Do not use rental CDs with old labels that are beginning to peel off.
Stickers that are beginning
to peel away, leaving a
**************
*******
*******
sticky residue (P .6).
*******
P . 6
Do not use your CDs with labels or stickers attached.
Labels are attached (P .7).
*******
*******
*******
*******
*******
P . 7
Do Not Use Special Shape CDs
Be sure to use round shape CDs only for this unit and do not use
any special shape Cds. Use of special shape CDs may cause
the unit to malfunction.(P .8).
P . 8
Be sure to use CDs with disc mark
RECORDABLE
REWRITABLE
Only for this unit.
CD-Rs and CD-RWs which have not undergone finalization
processing cannot be played. (For more information on
finalization processing, refer to the manual for your CD-R/CD-RW
writing software or CD-R/CD-RW recorder.) Additionally,
depending on the recording status, it may prove impossible to
play certain CDs record on CD-R or CD-RW.
2.INSTALLATION
Before finally installing the unit, connect the wiring temporarily and make sure it is all connected up properly
and the unit and system work properly.
Use only the parts included with the unit to ensure proper installation. The use of unauthorized parts can
cause malfunctions.
Consult with your nearest dealer if installation requires the drilling of holes or other modifications of the vehicle.
Install the unit where it does not get in the driver's way and cannot injure the passenger if there is
a sudden stop, like an emergency stop.
If installation angle exceeds 30° from horizontal, the unit might not give its optimum performance.
Avoid installing the unit where it would be subject to high temperature, such as from direct sunlight, or from hot
air, from heater, or where it would be subject to dust dirt or excessive vibration.
Be sure to remove the front panel before installing the unit.
DIN FRONT/REAR-MOUNT
This unit can be property installed either from "Front" (conventional DIN Front-mount) or "Rear"(DIN Rear-mount
installation, utilizing threaded screw holes at the sides of the unit chassis). For details, refer to the following
illustrated installation methods A and B.
- DIN FRONT-MOUNT (Method A)
Installation the unit
1
2
182
53
3
1
6
7
4
5
2
3
30°
1. Dashboard
2. Holder
After inserting the half sleeve into the
dashboard, select the appropriate tab
according to the thickness of the
dashboard material and bend them
inwards to secure the holder in place.
3. Screw
1. Dashboard
2. Nut (5mm)
3. Spring washer
4. Screw (5x25mm)
5. Screw
6. Support Strap
Be sure to use the support strap to
secure the back of the unit in place. The
strap can be bent by hand to the desired
angle.
7. Plain washer
Page 3
