General Safety Instructions; Cleaning And Care; Special Safety Instructions For This Device - BOMANN HTD 889 CB Instrucciones De Servicio

General Safety Instructions

Read the operating instructions carefully before putting the
appliance into operation and keep the instructions including the
warranty, the receipt and, if possible, the box with the internal
packing. If you give this device to other people, please also pass
on the operating instructions.
• The appliance is designed exclusively for private use
and for the envisaged purpose. This appliance is not fi t
for commercial use. Do not use it outdoors (except if it is
designed to be used outdoors). Keep it away from sources
of heat, direct sunlight, humidity (never dip it into any liquid)
and sharp edges. Do not use the appliance with wet hands.
If the appliance is humid or wet, unplug it immediately.
• When cleaning or putting it away, switch off the appliance
and always pull out the plug from the socket (pull on the
plug, not the cable) if the appliance is not being used and
remove the attached accessories.
• Do not operate the machine without supervision. If you
should leave the workplace, always switch the machine off
or remove the plug from the socket (pull the plug itself, not
the lead).
• Check the appliance and the cable for damage on a regular
basis. Do not use the appliance if it is damaged.
• Do not try to repair the appliance on your own. Always
contact an authorized technician. To avoid the exposure
to danger, always have a faulty cable be replaced only by
the manufacturer, by our customer service or by a qualifi ed
person and with a cable of the same type.
• Use only original spare parts.
• Pay careful attention to the following "Special Safety Instruc-
tions".
Children and Frail Individuals
• In order to ensure your children's safety, please keep all
packaging (plastic bags, boxes, polystyrene etc.) out of their
reach.
Caution! Do not allow small children to play with the foil as
there is a danger of suffocation!
• In order to protect children or frail individuals from the ha-
zards of electrical equipment, please ensure that this device
is only used under supervision. This device is not a toy. Do
not allow small children to play with it.

Special safety instructions for this device

Symbols on the Product
On the products you will fi nd symbols that indicate warnings or
provide information:
Warning of electric shock!
Do not use this device near baths, wash basins or
other vessels containing water.
• Attention: The nozzles become hot during operation.
• If the hair dryer is used in the bathroom, remove the mains
plug after use as water represents a hazard. This also
applies when the hair dryer is switched off.
16
05-HTD 889 CB .indd 16 05-HTD 889 CB .indd 16
• As additional protection we recommend the installation of a
fault current protection device (RCD) with a rated current of
not more than 30 mA in the wiring system of the bathroom.
Please contact an authorised electrician for advice.
Commissioning
1. Fully unwind the mains cable.
2. Fit on a nozzle. You can dry single hair locks by concent-
rating the fl ow of hot air with the hairdressing nozzle. The
diffuser is the ideal solution to dry curly hair without losing
volume. In order to replace the attachment, fi rst remove the
old attachment by pulling it off and then pushing on the new
one until it clicks into place.
3. Only connect the machine to a properly installed safety
socket, 230 V/50 Hz.
Setting the Temperature Level (right switch):
Position •: cold air
Position • •: medium temperature for gentle drying and
shaping.
Position • • •: high temperature for rapid drying.
Setting the desired blower strength (left switch):
Position 0: off
Position : gentle stream of air
Position : strong stream of air
Button : With this switch it is possible to interrupt
the heating process so that the air can be
mixed according to individual requirements.
Hold the button down in this position
according to the desired interval length.
When the button is released it returned
automatically to the initial position.
4. Move the left-hand switch after use to the „0" position and
remove the mains plug. Leave the device to cool before
putting it away! Hang the device up by the suspension eye.

Cleaning and care

• Before cleaning remove the mains lead from the socket.
• Clean the housing with a soft, dry cloth without additives.
• The device must never be immersed in water!
Air Intake Grill
• Please clean the grill on the air intake side of the hairdryer
regularly in order to avoid excessive temperatures as a
result of heat accumulation.
• Remove any dirt that is present. If necessary, a fi ne brush
can be used.
• Twist off the grille in an anticlockwise direction, remove the
air inlet fi lter and clean it under running water.
• Please allow the fi lter to try before reinserting it.
• Turn the grille tight in a clockwise direction.
20.11.2007 9:23:18 Uhr 20.11.2007 9:23:18 Uhr