Uline H-5607 Guia De Inicio Rapido

π
WIRE MACHINE GUARD
TOOLS NEEDED
3/8" Masonry
Electric Drill
Drill Bit
(Screw Gun)
POST
Straight Bolt x 2
Curved Bolt x 4
Universal Post
Flange Nut x 4
Prior to installation, read instructions all the way through
and determine guard placement. The included
hardware allows for panels to be installed end to end,
as a 90º corner or as a T-intersection.
NOTE: Be sure to include the additional width
of the posts and mounting plate dimensions
when determining placement.
NOTE: One side of the post features four drill
holes for attaching the door. Make sure to
position the post in the proper orientation if
attaching a door to the other side.
MOUNTING THE POSTS
1. Verify that the first post is positioned in the desired
location. Mark the floor where the holes will be drilled.
2. Using a 3/8" masonry drill bit, drill a hole approximately
3" deep into the floor. (See Figure 1)
Clean out debris and dust from inside the hole, and
fully insert anchor bolt through the mounting plate
and into the hole.
PAGE 1 OF 6
1-800-295-5510
uline.com
13mm Wrench
Concrete Anchor x 4
(10mm x 90mm)
Black Plastic
Lock Washer x 4
Plug x 8
Flat Washer x 4
INSTALLATION
17mm Wrench
PARTS
DOOR
Door
Figure 1
Anchor Bolt
3/8"
Masonry
Bit
3. Slightly tap down the anchor bolt with a hammer
if needed. Slide washer onto anchor bolt. Using a
17mm wrench, tighten the hex nut until the anchor
bolt is secure. Repeat for remaining anchors.
Para Español, vea páginas 3-4.
Pour le français, consulter les pages 5-6.
Self-tapping Screw
5' Models x 6
7' Models x 8
Nut Driver x 1
Door Hasp x 1
PANEL
Panel
0721 IH-5607