golmar TEKNA S PLUS Guía Rápida página 3

PROGRAMMING
PROGRAMMING THE TEKNA S PLUS MONITOR WITH A BUTTON PANEL
Locate on the door panel the SW2 DIP switch situated on the top left-hand side of the back of the sound
module and set number 2 to ON. The door panel will emit a tone to indicate that it has entered
programming mode.
In systems with more than one door panel, only perform this procedure on the main panel of each
building.
Turn off the monitor to be programmed (press button
Once switched off, press door release button
Press and hold door release button and, without releasing it, switch
on the monitor (press button for 1 second).
To show that the device is ready for programming, the door panel and
monitor will emit a number of tones (the status LED on the monitor will
illuminate red), enabling door release button
establish audio communication with the door panel, lift the handset.
Press the door panel button that will call this monitor.
At this moment, the door panel and monitor will emit a number of
tones (the status LED on the monitor will blink red).
To programme the monitor as , press button
Master
(the monitor's LED will illuminate red).
Para programarlo como Secundario 1 pulsar el botón
de estado parpadeará (en color verde) una vez y así sucesivamente
hasta 4 pulsar el boton cuatro veces, el led de estado
Secundario
parpadeará (en color verde) cuatro veces.
To programme it as , press button
Slave + Intercom
blink (green) once.
To programme it as (in call), press button
Slave without video
the status LED will blink (green) once. If button
the monitor will return to being programmed as
call) and the status LED will blink (green) twice. The door panel video
will be displayed during a call if programmed to do so.
Make a call to check that the monitor has been successfully programmed.
Programme the other monitors in the same way.
Once the programming has finished, set the programming switch to OFF.
Each apartment must only have one master unit; if there are parallel
units, they must be configured as slaves.
IMPORTANT:
I
- To programme the monitor with a coded door panel or from a general panel, see the corresponding door panel
- For advanced programming, optional connections and more information, see the TTEKNA S PLUS manual (code
50122251). https://doc.golmar.es/search/manual/50122251
for 3 seconds).
.
to be released. To
P
for 3 seconds
S
una vez, el led
SI
and the LED will
SV
and
is pressed again,
(in
Slave with video
4
TECHNOLOGY
TEKNA S PLUS MONITOR
PLUS DIGITAL SYSTEM
Golmar se reserva el derecho a cualquier modificación sin previo aviso.
Golmar se réserve le droit de toute modification sans préavis .
Golmar reserves the right to make any modifications without prior notice.
Web
manual .
EN
QUICK GUIDE
Code 5012 2 251
T TEKNA S PLUS N
[email protected] www.golmar.es
Sistemas de comunicación S.A.
REV.0121
E GR
EN