Tabla de contenido
Idiomas disponibles
Idiomas disponibles
1. Introduction
Manufacturer:
scheppach
Fabrikation von Holzbearbeitungsmaschinen GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer,
We hope your new tool brings you much enjoyment
and success.
Note:
According to the applicable product liability laws, the
manufacturer of the device does not assume liability
for damages to the product or damages caused by
the product that occurs due to:
• Improper handling
• Non-compliance of the operating instructions
• Repairs by third parties, not authorized service
technicians
• Installation and replacement of non-original spare
parts
• Application other than specified
• A breakdown of the electrical system that occurs
due to the non-compliance of the electric regu-
lations and VDE regulations 0100, DIN 57113 /
VDE0113
Please observe the following:
Read through the complete text in the operating instruc-
tions before installing and commissioning the device.
The operating instructions are intended to help the
user to become familiar with the machine and take
advantage of its application possibilities in accord-
ance with the recommendations.
The operating instructions contain important infor-
mation on how to operate the machine safely, pro-
fessionally and economically, how to avoid danger,
costly repairs, reduce downtimes and how to in-
crease reliability and service life of the machine.
In addition to the safety regulations in the operating
instructions, you have to meet the applicable regu-
lations that apply for the operation of the machine in
your country.
Keep the operating instructions package with the
machine at all times and store it in a plastic cover
to protect it from dirt and moisture. Read the instruc-
tion manual each time before operating the machine
and carefully follow its information. The machine can
only be operated by persons who were instructed
concerning the operation of the machine and who
are informed about the associated dangers. The min-
imum age requirement must be complied with.
In addition to the safety instructions contained in this op-
erating manual and the specific regulations of your coun-
try, the technical rules generally accepted for the oper-
ation of machines of the same type must be observed.
28 | GB
We accept no liability for damage or accidents which
arise due to non-observance of these instructions
and the safety information.
2. Device description
1.
Table de sciage
2.
Saw blade guard
3.
Riving knife (not visible)
4.
Saw blade (not visible)
5.
Table insert
6.
Table width extender
7.
Locking handle
8.
Scale
9.
Handwheel
10. Crank handle
11. Base frame
12. On/off switch
13. Cam lever
14. Parallel stop with knurled nut (i)
15. Guide rail long
15a. Guide rail short
15b. End caps
16. Suction adapter
17. Push stick
18. Bracket for saw blade storage
19. Legs
20a. Central strut A (2x)
20b. Central strut B (2x)
21. Rubber feet (4x)
22. Stand brackets (2x)
23. Attachment points
24. Table brackets,
25. Countersunk screws of the table insert
26. Fixing screws of the riving knife
27. Screw with nut and washer
28a. Groove
28b. Groove
29. Knurled screw
30. Stop rail
31. Transverse stop with knurled nut (i)
32. Sight glass
32a. Sight glass screw
33. Laser
34. Switch Laser
35. Screw battery compartment
36. Battery cover - 2 LR03 / AAA, 1.5V batteries are
necessary for the operation of the Laser) (Bat-
teries not supplied)
3. Scope of delivery
• Table saw with pre-mounted 24 tooth saw blade
• Saw blade guard
• Riving knife
• Parallel stop
• Stop rail
• Transverse stop
Capítulos
Tabla de contenido
