Tabla de contenido
Idiomas disponibles
Idiomas disponibles
SAVE THESE INSTRUCTIONS
WARNING:
MISUSE or failure to follow the safety
rules stated in this instruction manual
may cause serious personal injury.
SYMBOLS
The followings show the symbols used for tool.
V............................volts
A ...........................amperes
Hz..........................hertz
....................alternating current
.......................no load speed
.......................Class II Construction
.../min....................orbits per minute
FUNCTIONAL DESCRIPTION
CAUTION:
•
Always be sure that the tool is switched off and
unplugged before adjusting or checking function on
the tool.
Switch action
CAUTION:
•
Before plugging in the tool, always check to see
that the switch trigger actuates properly and returns
to the "OFF" position when released.
•
Switch can be locked in "ON" position for ease of
operator comfort during extended use. Apply
caution when locking tool in "ON" position and
maintain firm grasp on tool.
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop.
For continuous operation, pull the switch trigger and then
push in the lock button.
USD205-1
003281
1
1. Lock button
2. Switch trigger
2
To stop the tool from the locked position, pull the switch
trigger fully, then release it.
ASSEMBLY
CAUTION:
•
Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
Installing or removing abrasive paper
For conventional type of abrasive paper with pre-
punched holes (standard equipment):
1
2
Press the clamper. Insert the paper end into the clamper,
aligning the holes in the paper with those in the pad.
Then release the clamper to secure the paper. Repeat
the same process for the other end of the base, maintain-
ing the proper paper tension.
For conventional type of abrasive paper without pre-
punched holes (available on the market):
1
2
Press the clamper. Insert the paper end into the clamper,
aligning the paper edges even and parallel with the sides
of the base. Then release the clamper to secure the
paper. Repeat the same process for the other end of the
base, maintaining the proper paper tension.
Place the punch plate (optional accessory) over the
paper so that the guide of the punch plate is flush with
the sides of the base. Then press the punch plate to
make holes in the paper.
4
003308
1. Clamper
2. Abrasive paper
with pre-
punched holes
3. Pad
3
003310
1. Abrasive paper
without pre-
punched holes
2. Punch plate
Tabla de contenido
