TaoTronics TT-SL209 Guia Del Usuario página 4

How to Use
Assembly
Mounting the Ground Stake
• Use the Allen key to remove the screw and washer from the ground stake.
• Mount the laser light on the stake using the screw on the pivot hole
(See Assembly Diagram 1).
• Plug in the cable to the adapter, and then connect the adapter to a power source.
• Screw on the weather resistant cap tightly to protect the connector from the
weather (See Assembly Diagram 2).
• Stick the stake into the ground. Be careful to steer away from wires or hoses.
• Adjust the projection position by loosening and tightening the angle adjustment
screws (See Assembly Diagram 1).
All manuals and user guides at all-guides.com
(UK/EU)
(US/CA)
Using the Remote
Install the included two AAA batteries in the remote. To test the battery connection,
press any button and the LED will illuminate for 1 second. If the LED does not light on,
check and make sure you have installed the batteries following the correct polarities.
Remote Control Buttons
ON / OFF: Turn the light on & off.
Color: Cycle through 3 color patterns from red, green, and red / green combination.
Flash: Control the speed at which the light ashes (Slow, Medium, Fast, or Static).
Motion Speed: Control the speed at which the animated light pattern moves (Slow,
Medium, Fast, or Static).
Timer Reset: Press the Timer Reset Button before setting the timer. The red lights will ash
3 times. Then select a time (2h / 4h / 6h / 8h) and both the red / green lights will ash
3 times to indicate you have successfully set the timer. If you need to change the timer
setting, press the Timer Reset Button again to clear the setting and repeat the current
step. If no timer is set, the light will stay on.
2h: Turn the light off after 2 hours of use.
4h: Turn the light off after 4 hours of use.
6h: Turn the light off after 6 hours of use.
8h: Turn the light off after 8 hours of use.
03/04