Tabla de contenido
Idiomas disponibles
Idiomas disponibles
a
Quick start guide
Terrace Heater
For more information see the extended manual online:
ned.is/htpa20ebk
Intended use
The Nedis HTPA20EBK is a convection heater with 2 temperature
settings.
This product is not intended for professional use.
The protective cover of this product is intended to prevent direct
access to heating elements and must be in place when the heater
is in use.
Any modification of the product may have consequences for safety,
warranty and proper functioning.
Specifications
Product
Article number
Dimensions (l x w x h)
Weight
Input voltage
Maximum output power
IP rating
Cable length
Main parts (image A)
Heating unit
1
2
Heating element
Protective cover
3
Base stand
4
Safety instructions
-
WARNING
• Ensure you have fully read and understood the instructions in
this document before you install or use the product. Keep the
packaging and this document for future reference.
• Only use the heater indoors or outdoors under roofed areas.
• If used outdoors, protect the heater against weather influences.
• Only use the product as described in this document.
• Do not use the product if a part is damaged or defective. Replace
a damaged or defective product immediately.
• Do not use the product where splashing of water might occur,
e.g. bathroom, swimming pool or close to a washbowl.
• Do not expose the product to water or moisture.
• Do not drop the product and avoid bumping.
• Do not open the product.
• Keep the product out of reach from children, infirm persons or
animals.
• Children and persons with reduced physical, sensory, or mental
capabilities or lack of experience may not use the product
without supervision.
• Do not use the product when the cable or plug is damaged.
• Keep hands and utensils out of the protective cover to reduce the
risk of severe injury to people or the product.
• Children of less than 3 years should be kept away unless
continuously supervised.
• Disconnect the product from the power source before service
and when replacing parts.
• Make sure that the function dial is in the OFF position before
disconnecting the product.
• Make sure that the voltage of your power outlet matches the
voltage required by the product.
• Keep the product away from flammable objects such as furniture,
curtains and similar.
HTPA20EBK
Terrace Heater
HTPA20EBK
27 x 27 x 82 cm
3 kg
220 – 240 V ~ 50 Hz
1200 W
IP24
1.4 m
Power cable
5
6
Handle
Function dial
7
• Do not use a damaged product.
• Children aged from 3 years and less than 8 years shall only switch
on/off the product provided that it has been placed or installed
in its intended normal operating position and they have been
given supervision or instruction concerning use of the product in
a safe way and understand the hazards involved. Children aged
from 3 years and less than 8 years shall not plug in, regulate and
clean the product or perform user maintenance.
• Do not cover the product.
• This heater is not equipped with a thermostat to control the
room temperature. Don't use this heater in small rooms when
they are occupied by persons not capable of leaving the room on
their own, unless constant supervision is provided.
• Do not splash water onto the product.
• Do not use external timers or remote control systems to switch
the product on or off.
• Never touch the protective cover, this may cause burns or severe
injury.
• Do not leave the product unattended when switched on.
• Do not let water enter the product.
• Do not place the product on moving vehicles or somewhere easy
to be tipped over.
• Do not move the product during operation.
• Do not let the power cable hang over the edge of a table or
counter, or touch hot surfaces.
• Using an extension cord is not recommended. If an extension
cord is inevitable, use one which exceeds the power rating of the
heater, is as short as possible and fully extended to prevent
overheating.
• Unplug the power cable when the product is not in use for a long
time.
• Do not locate the product immediately below a power outlet.
• Unplug the product from the power source and other equipment
if problems occur.
• Do not unplug the product by pulling on the cable. Always grasp
the plug and pull.
• Do not use the product in rooms where flammable liquids or
gases are used or stored.
• This product may only be serviced by a qualified technician for
maintenance to reduce the risk of electric shock.
Installing the product
Place the product on a stable and flat surface.
-
Do not place the product within 1m of any object, wall or ceiling.
Using the product
-
Make sure the function dial A
before plugging the power cable A
1. Plug the power cable A
The product has three operation modes.
Icon
Description
0
Off
1
Low (600W)
2
High (1200W)
Oscillation mode (1200W)
2. Turn A
7
to switch between modes.
When you set A
to the oscillation setting, the fan oscillates on
4
7
the base stand A
4
.
The heater is fitted with a tilt sensor. This sensor is a safety
4
precaution that switches off the heater in case it has fallen over.
Switching off the product
1. Set A
7
to 0 to switch off the heater.
2. Unplug A
5
from the power outlet.
-
Allow the product to cool down before storage.
4
is switched to the off position
7
5
into a power outlet.
5
into a power outlet.
Tabla de contenido
