Machine Operation; Pre--Operation; Cleaning Carpets; While Operating - Nobles Power Eagle 1016 Plus Manual Del Operador Y Piezas

MACHINE OPERATION

FOR SAFETY: Do not operate machine unless
operator manual is read and understood.
PRE- -OPERATION
1. Vacuum carpet to remove particles and other
debris.
2. Inspect power cord for damage. Replace cord if
damaged.

CLEANING CARPETS

WARNING: Do Not Pick Up Flammable
Materials Or Reactive Metals.
1. Turn on Vacuum/Pump switch.
NOTE: Solution spray is activated when the
Brush/Spray button is pushed.
2. To begin cleaning, push button and slowly pull
machine backwards at a pace of approximately
3m (10 ft.) per 15 seconds (Figure 5).
FIG. 5
3. Release button at end of path and continue to pull
machine backwards for another 30cm (12 in) to
pick up excess solution.
4. Tip machine back and push forward to return at
begining of next path.

WHILE OPERATING

1. Overlap each path by 50mm (2 in).
2. Work away from wall outlet and power cord to
prevent cord damage.
3. Check for excessive foam buildup in recovery
tank. Use a recommended foam control solution to
prevent vacuum motor damage.
Power Eaglet 1016/1020 Plus (04- -02)
Find... Go To..
Home
ATTENTION: Excessive foam buildup will not
activate the float shut-off screen. Vacuum motor
damage may result.
4. If brush stops, the circuit breaker may have been
tripped. Unplug power cord, check brush for
obstruction OR raise brush height. Push brush
reset button located under switch box to resume.
5. Repeat cleaning path for heavily soiled areas.
6. Once water recovery stops, or when solution tank
runs dry, you must drain recovery tank
(See DRAINING TANKS).

CLEANING WITH ACCESSORY TOOLS

1. Disconnect vacuum hose from dome and replace
with accessory vacuum hose. Connect accessory
solution hose to quick coupler located in front of
handle (Figure 6).
FIG. 6
2. Attach desired accessory tool to hoses.
3. Turn on Vacuum/Pump switch.
4. Operate accessory tools as normal (Figure 7).
NOTE: When cleaning upholstery, always check
cleaning instructions sewn in furniture by
manufacturer.
FIG. 7
5. After cleaning, relieve water pressure from tool
before disconnecting hose. Squeeze trigger for
five seconds after turning off switch.
OPERATION
7