Maxell YOSO PRO Manual Del Usuario página 5

The standard charging time is 5 hours.
The device can be used approximately 10 times on a single charge.
(1 time means that all modes are being used once at "High" level.)
Depending on the operating conditions such as the ambient temperature,
operating times may decrease.
Time to charge
When the power is ON, if a warning sound can be heard, it is a signal to indicate
recharging. Charge as soon as possible.
In order to make full use of battery performance, observe the following.
(1) If you have not used for three months or longer, or charge for every use,
operating times may become smaller even if you charge at the next time.
[This is due to deactivation of the battery (slow charge reaction) and memory effect.]
How to activate battery
1) Use the battery until the charge request sound is made.
2) Charge for 5 hours as a standard in accordance with "How to charge."
3) After pulling out the power plug from an electric outlet, plug in again and charge
for 5 hours.
Repeat 1) through 3) a few times, then the batteries are activated.
(2) When using for the first time
If the number of operating times is small even when the batteries are charged
for 5 hours, charge according to the above method to activate the battery.
(3) Charge the battery at an ambient temperature from 5 to 35
Preparation before use
Never use the device when you have a wound or an inflammation on
your skin. (Cause of problems with or damage to your skin.)
Remove jewelry or contact lenses.
(Cause of problems with your skin or poor health)
1. About mode switching
Mode Materials needed
CLEANSE (cleans fine residue Use new cotton saturated with your regular toner.
remaining in pores)
MOISTURISE (performs moisturizing Use new cotton saturated with your regular toner.
care by allowing moisturizing If you use a gel-like or thick toner, you can also
apply it to head without using cotton.
ingredients to penetrate into skin)
BOOST (enhances the effect of milky Use your regular milky lotion or a sheet mask by
lotion or sheet mask) applying to skin. Do not use cotton.
2. Clean skin by washing your face so that makeup and dirt will wash off.
●
Wipe off makeup with a cleansing product.
3. Attach cotton to the body of the device. (Fig. 4)
The narrower side of the inner circumference should be upward.
(1)Remove the protection seal from the head.
● Unless the protection seal is removed, the device will not operate.
(2)Place cotton over the head and attach it with the included ring.
● Use commercially available cotton. However, small cotton or thick cotton may not
work in some cases.
All manuals and user guides at all-guides.com
.
Cotton
-5-
The ring has an orientation with a clear direction. Attach it from straight above with
●
the wider part of the inner circumference placed toward the head.
Do not attach the ring in the reverse direction. Please be careful
not to squeeze it, otherwise, it cannot be removed.
4. How to remove the ring. (Fig. 5)
● Remove the ring by pulling it straight up while holding down the lower part.
5. Please observe the following so as not to damage your skin when you use the device.
(1) The maximum amount of time allowed for skin care with use of this device is
approximate 10 minutes per day in basic mode.
(Limit use of each step to no more than 5 minutes per day.)
Basic mode
"CLEANSE"
<Automatic shutoff>
Step 1
(approximate 5 minutes)
"MOISTURISE"
Step 2
(approximate 5 minutes)
Step 3
enhances the effect of milky
lotion or sheet mask
● Limit use of the device to no more than 15 minutes per day including use of
"BOOST."
● It is recommended that you use "BOOST" once or twice a week.
(2) Use the device on bare skin after removing makeup.
(3) Do not use the device on the same area of skin for more than 10 seconds.
(4) Switch between high and low by pressing the Level switch button according to the
condition of your skin.
●
You can choose "HIGH," "MEDIUM," and "LOW" as you like. If your skin tingles,
use the device on "LOW."
● If you feel something unusual with your skin, stop using the device and consult a
skin care specialist.
● The device is equipped with a memory function to memorize the levels of "HIGH,"
"MEDIUM," and "LOW" that you would normally use. For details, please see "About
memory function" .
Examples of use
Press the mode switch button and set the mode of your preferred treatment.
Quick treatment (Required time: approximate 5 minutes)
● Step 2 "MOISTURISE"
When you do not have much time in the morning or when you need to go out suddenly,
you can just use the "MOISTURISE." That will moisturise your skin in approximate 5
minutes. Press the mode switch button and set to "MOISTURISE."
MOISTURISE treatment (Required time: approximate 10 minutes)
● Step 1 "CLEANSE"
● Step 2 "MOISTURISE"
Before you go out or when you have more time, use the "MOISTURISE" after using
"CLEANSE."
This will moisturise your skin thoroughly.
<Automatic shutoff>
"BOOST"
<Automatic shutoff>
(approximate 5 minutes)
-6-