Using The Jumpstart - PowerStation PS1118 Manual Del Usuario

USE OF THE PS1118

Using the Jumpstart

The PS1118 can be used to jumpstart any standard size vehicle or boat with
a single 12V starting battery.
The following steps should be read completely before starting this
procedure and then carefully followed throughout the procedure:
1. Ensure safety of immediate area. See warnings at the beginning
of this manual for further details.
2. Turn off the vehicle or boat, as well as all attached accessories such
as lights, radios, et cetera.
3. Be sure that the emergency brake is engaged. Manual transmission
vehicles should be in neutral. Automatic transmission vehicles
should be in park.
4. If jumpstarting a boat engine, purge the engine compartment and
vent fumes per boat manufacturer instructions before proceeding.
5. Position the PS1118 on a secure, level surface in reach of the battery
but away from all electrical and moving parts of the engine. Please
note, some engine components may be hot enough to cause severe
burns or damage the PS1118.
6. Connect red POS (+) clamp to red POS (+) battery terminal first.
7. Connect black NEG (-) clamp to engine ground or non-moving
metal part.
8. Double check to ensure booster cables are clear of ALL moving
engine parts.
9. Turn on ignition and crank engine. If the engine does not start within
6 seconds, stop and wait 3 minutes before re-trying. This will ensure
your PowerStation® battery is not damaged due to overheating.
10. Once engine has started, disconnect the black NEG (-) clamp first.
Then, remove the POS (+) clamp and return both cables and clamps
to their stored position.
012807
All manuals and user guides at all-guides.com
continued
PS1118 Owners Manual Page 8