6
COMMISSIONING
6.3
Additional functions
7
Troubleshooting
14
If the switching output fails to behave in accordance with the above diagram, check the
application conditions,
see figure 4, page 13
Information on the IO-Link functions can be found in the Technical information Photo‐
electric Sensors, SICK Smart Sensors/ IO-Link which is available for download from
www.sick.com (search for the device's part number).
Table 2: Process data structure (IO-Link version: V1.1 Process data length: 4 bytes)
No.
Bit 0
Bit 1
Bit 2
Bit 3
Bit 4
Bit 5
Bit 6
Bit 7
Bit 8
Bit 9
Bits 10...15
Bits 16...31
Table 3: Fault diagnosis
Display, error situation
Green LED flashes
Switching outputs not accord‐
ing to graphic C
Switching outputs not accord‐
ing to graphic C
Yellow LEDs flash at the same
time
Yellow LED flashes (only
briefly)
Yellow LED flashes fast, laser
is off, ISDU 36 shows "out of
specification" and one of the
.
Description
Byte 0: bits 31...24
Byte 1: bits 23...16
Byte 2: bits 15...8
Byte 3: bits 7...0
Q
L1
Q
L2
Qint.1
Qint.2
Qint.3
Qint.4
Qint.5
Qint.6
Qint.7
Qint.8
Empty
Analog value
Cause
IO-Link communication
IO-Link communication
Parameter settings made
manually, which deviate from
the standard
The sensor is not ready for
operation. The sensor will be
in the warming-up phase at
low ambient temperatures.
The sensor will have shut
down at excessively high
ambient temperatures.
Teach-in mode
The device enters the no-oper‐
ate state as it is operated out‐
side the specification (too
high/low temperature).
Data type
Boolean
Boolean
Boolean
Boolean
Boolean
Boolean
Boolean
Boolean
Boolean
Boolean
-
UInt16
Measure
Initiate a factory reset. The
switching outputs are reset to
factory settings.
At low ambient temperatures,
wait until the sensor has
warmed up. Ensure the sensor
cools down at excessively high
ambient temperatures.
Check the teach-in mode
Operate the device only within
the specification.
8022570 | SICK
Subject to change without notice