Allen + Roth CO.VS200 Instrucciones De Ensamble página 5

ASSEMBLY INSTRUCTIONS
4. Attach the knobs (DD) by using the 1 in.
screws (BB).
Hardware Used
DD
Knobs
BB
1 in. Screw
5. Place the vanity base (A) in the desired position,
taking into account the location of your plumbing.
Ensure the vanity base (A) is level. Insert two wall
anchors (if applicable) and secure the vanity
base (A) to the wall by inserting two M8 x 2 in.
screws (not included) through the back rail of the
vanity base (A).
6. Ensure the vanity surface is flat, level and clean.
Put a small bead of silicone on the vanity base (A)
top edge. Place the vanity top (C) on the vanity
base (A) and assure it is aligned on all edges.
Let silicone set for at least 3 hours. If any warpage
is obvious, put a weight on top of a towel over
the high points and leave overnight to settle.
Align the vessel sink (E). Attach the vessel sink (E)
and drain (F) separately as per the instruction
sheets provided with those items. Note: The O-ring
must be installed between the vessel sink (E) and
the vanity top (C). Failing to install the O-ring
may result in leakage through the vessel sink (E)
and/or the vessel sink (E) cracking. Note: Use
100% silicone instead of plumber's putty between
all rubber gaskets and O-rings.
x 2
x 2
5
4
DD
5
A
6
F
A
BB
E
C
A