BluMill Electric Step Instrucciones De Uso página 5

REMOVABLE PLATFORM
EN
The platform is removable to gain access to the batteries. Simply remove the
four deck screws with a Phillips screwdriver (fig. 5), and lift off the platform.
Reverse procedure to replace platform.
USE A PHILLIPS SCREWDRIVER TO REMOVE PLATFORM
CAREFULLY REMOVE SCREWS, SPRING AND BRAKE PEDAL TO GAIN BATTERY
ACCESS.
DRIVE BELT ADJUSTMENT AND REPLACEMENT
Periodic adjustment of the drive belt is highly required. The belt will become
loose after hours of operation. Thus, when this happens, the belt will make a
popping sound while accelerating. When this occurs, you must tighten the drive
belt immediately. To tighten the belt, slightly loosen near rear axle nuts and
rotate the belt adjuster discs equally (fig. 6). Tighten axle nuts and recheck belt
tension.
8
Fig. 5
Fig. 6
DRIVE BELT ALIGNMENT
If you experience either the drive belt coming off the drive gear or the wheel
gear and/or rubbing against the scooter frame, there most likely is belt misalig-
nment. To re-align, carefully place the scooter upside down on a sturdy surface
(table, stool, etc.) and determine the direction of the belt-side movement (fig. 7).
You will slightly need to move the rear wheel left or right to re-align. To do this,
slightly loosen axle nuts and rotate the belt adjuster discs. Tighten axle nuts and
check alignment by engaging power. Recheck alignment after riding; readjust if
necessary.
*Installation of Seat (For models with seats only)
Important:
Press down the seat column into the hole on the main board. Ensure the snap
pin pops out and lock the piece properly, and clip firmly. Insert the seat into the
upper hole, use a spanner to tighten the locking net, ensure the seat is stable to
use. The seat can only be used with this product when the steering is completely
locked. This must be checked by an adult prior to use.
EN
Fig. 7
9