Oce CS6407 Guía De Consulta Rápida página 10

17
Enter the remaining media.
Enter the remaining roll media loaded on the printer.
S E T R E M A I N I N G M E D I A
* X X X m
Note
- After installing the media, check whether the media on the
platen has no fl oat or wrinkles.
18
This sign is displayed when the slack is
insuffi cient.
- In case of use of sheet media, this message is not
displayed.
- If the media slackness is insuffi cient, the next
operation will not be started.
C H E C K
S L A C K E N M E D I A
19
Press the tension bar to the peel roller's upper
part. Then create a slack between the platen
and the peel roller, by carrying the tension
bar to the rear side of the peel roller with a
supply-side feed switch.
Tension bar
Adjust the tension bar length and decide whether to
attach a fl ange or not, depending on the type and
width of the media.
Examples of tension bar combinations
Size used
L
L, S
L, S, S
10
All manuals and user guides at all-guides.com
<General media in TENSION winding mode>
Put a tension bar suitable for the media width.
Usually put a tension bar suitable for the media width with a
few exceptions.
<General media without take-up reel unit>
Put a tension bar which is half the width of the media.
<Vinyl chloride media>
Put an S size tension bar (without a fl ange) on the center of
the slack.
Supply-side slack sensor
Slacken off to a level lower than the supply-side slack sensor.
When the slack reaches the sensor detection area, the
operation panel blips.
Note
20
Switch
Tension bar
Note
Tension bar length
48 inches (123 cm)
64 inches (164 cm)
80 inches (204 cm)
Peel roller
r
- Be sure to rotate the panel with the supply-side feed switch.
Do not rotate the peel roller manually, or the printer may be
damaged.
Check the media setting.
Press the key.
S E T M E D I A
* O K ?
P R E P A R I N G M E D I A
P L E A S E W A I T
- Rewind the printer's media completely at the end of the day. The
PVC media installed and left for a night on the printer may cause
media jam.
S S Scroller fl ange