Uline H-7704 Guia De Inicio Rapido página 2

3. Insert six leg screws
(3) into the sides
and underside of
the channel (1).
Tighten loosely using
the Allen wrench (11).
Repeat on opposite
side. (See Figure 4)
NOTE: All screws will be fully tightened when
frame is completely assembled.
4. Attach the side frame pieces (4) to the end of each
side by using four leg screws (3). Tighten loosely with
the Allen wrench (11). (See Figure 5)
Figure 5
5. Place the table top (5) upside down on a clean,
smooth, non-marring surface to prevent scratching.
6. Place frame on table top (5). Adjust position of
frame so that it is centered on the table top.
(See Figure 6)
NOTE: Lever (7) should be on the opposite side
of the two grommet holes. Back of table top
has two grommet holes. Front of table top is
the opposite side.
7. Attach the side frames (4) and the channel (1) to
table top (5) using the drill and fourteen wood
screws (6). (See Figure 6)
Figure 6
6
PAGE 2 OF 9
ASSEMBLY CONTINUED
Figure 4
3
1
4
2
4
1
5
8. Place lever (7) so
that the handle is
flush with the front
edge of table top
(5). Attach using the
11
drill and four wood
screws (6).
(See Figure 7)
NOTE: The lever will be located on the right side
of the table when flipped onto its feet.
9. Attach foot (8) to leg (2) using four foot screws (9).
Tighten using Allen wrench (11). Repeat on opposite
side. (See Figure 8)
10. Insert casters (10) into holes on bottom of feet (8).
3
Use 14 mm wrench (12) to tighten into place.
(See Figure 8)
Figure 8
11. Table is now fully assembled. Using two people,
carefully flip the table onto the feet. (See Figure 9)
Figure 9
Figure 7
12
10
9
8
8
5
6
7
2
Lever
0821 IH-7704