Uline H-6575 Guia De Inicio Rapido

H-6575
ADA HEX PICNIC TABLE
TOOLS NEEDED
7/16" (11 mm) Socket Bit
Power Drill (Or Screw Gun)
5 Gallon Bucket (Optional)
Half Base x 2
Tabletop x 1
NOTE: It is important to keep screws loose
throughout assembly. Tighten during step 11.
1. Verify all parts are present before beginning.
May contain extra hardware.
2. Loosely attach the 4 leg anchor blocks to the
bottom of the 4 seats using the 3½" lag screws,
washers, power drill and 7/16" socket bit (will tighten
later in step 11). The bored hole on the leg anchor
block faces the side with three edges. (See Figure 1)
Figure 1
PAGE 1 OF 6
1-800-295-5510
uline.com
Tape Measure
Two Person Assembly
(Optional)
Full Base x 1
Support Arm x 3
ASSEMBLY
PARTS
Left Seat x 2
2½" Lag Screw 3½" Lag Screw
x 6
3. Place the 3 support arms on a flat level surface in
a fan pattern. Using the 3" drywall screws, loosely
attach the support arms together (will tighten later in
step 11). Use 2 drywall screws per side. (See Figure 2)
Figure 2
Para Español, vea páginas 3-4.
Pour le français, consulter les pages 5-6.
Right Seat x 2
Leg Anchor Block x 4
3" Drywall Screw
x 26 x 9
Washer x 32
0721 IH-6575