Connect Ductwork (Non-Ducted Configuration Only); Mounting Screws - KENMORE ELITE 233.5230 Serie Manual De Uso Y Cuidado / Instalacion

CONNECT DUCTWORK (Non-ducted configuration only)

1. Adjust the width of the flue mounting bracket
assembly to equal the inside width of decorative
flue. Insert and tighten mounting screws (3,9 x 6
mm) to hold bracket width.
FLUE MOUNTING
BRACKET
2. Use mounting screws (4,8 x 38 mm) and wall
anchors to secure flue mounting bracket assem-
bly to the ceiling as shown.
WALL
AN-
CHORS
3. Measure the distance from the top of the hood
outlet to the ceiling - and add 6 inches.
4. Cut a piece of 5" round flexible metallic duct
(not included) to the length determined in Step
3. Attach flange to bottom of flexible duct and
secure with duct tape.
5. Attach top of flexible duct to air baffle and
secure with duct tape.
6. Connect the flange to the hood outlet.
7. Turn upper flue section upside down so air vents
are at the top. Slide upper flue section into lower
flue section.
8. Set flue assembly on hood, with top tilted away
from wall. Align (4) holes in baffle with (4) holes
in top flue section.
9. Attach baffle to upper flue section with (4)
screws (3,4 x 15 mm Flat Head) (included). Use a
short screwdriver.
10. Extend the upper flue section to the ceiling and
secure to upper bracket with (2) mounting screws
(3,9 x 9,5 mm).
MOUNTING
SCREWS
(3,9x6mm)
MOUNTING
SCREWS
(4,8x38mm)
10
UPPER BRACKET
AIR BAFFLE
DUCT
TAPE
5" ROUND
FLEXIBLE
METAL
DUCT
DUCT TAPE
FLANGE
HOOD
OUTLET
AIR VENTS
UPPER
FLUE
SECTION
LOWER
FLUE
SECTION
MEASURE
& ADD 6
INCHES