KIKKA BOO LULU Instrucciones De Uso página 13

III. DISASSEMBLY
3.1. Installed product. Untie the Velcro under the bed.
3.2. Press the spring buckle and separate the steel tube under the bed.
3.3. Unzip the zipper of the crib' s cloth cover.
3.4. Separate the top support tube from the crib frame by pressing the spring pin on the inside of the crib.
3.5. Use the same method to separate the crib frame on the other side.
3.6. Take the crib away and start disassembling the crib frame.
3.7. Press the spring pin and separate the crib frames on both sides.
3.8. Separate the side frame stand of the crib frame, and use the same method to separate the side frame stand on the other side.
3.9. Separation of all crib frame tubes and tie the side frame stand with rope.
3.10. Fold the crib and bassinet frame.
3.11. Put the folded product into the carton and complete the packing.
IV. HOW TO CONNECT WITH AN ADULT BED
4.1. Pull the handles on both sides to adjust the height of the crib. First unzip the crib, then push the spring buckle in the opposite direction, and nally
remove the tube from the crib.
4.2. Four wheels with locking function to ensure more stable crib.
4.3. Take out the connectting strap and pass the buckle through the ribbon to connect the mother buckle under the crib. The other ribbon is connected in
the same way.
4.4. Unlock the safety buckle, pass the connecting strap under the mattress and buckle back the safety buckle to tighten the mattress.
- Unlock the safety buckle; B- lock the safety buckle;
After xing the crib, please try to push the bassinet to ensure that the gap between the crib and the adult bed does not exceed 13mm, if it is more than
13mm, readjust the adjusting buckle on the connecting belt. The four wheels of the bassinet need to be xed during use. Before using the crib, please roll
up the extra connecting belt and x it. Before using the crib, please check whether the connecting belt has been tightened.
ATTENTION: When the crib is connected to the adult bed, the lifting rail of the crib must be at the lowest position, and the height shall be lower than the
adult bed to avoid the baby falling o the crib.
4.5. Entrapment hazard: To prevent death from entrapment, bedside sleeper must be properly secured to adult bed using the attachment system.
There must be no more than 1/2in. (13 mm) gap between bedside sleeper and adult bed.
Check tightness before each use by pulling bedside sleeper in a direction away from adult bed.
If gap exceeds 1/2 in. (13mm), DO NOT use product. Do not ll the gap with pillows, blanckets or other items that are su ocation hazards.
Always use all required parts for each use mode. Check instruction manual for a list of required parts. Periodically check product for loose, damaged , or
misssing parts. The attachment system must always be used in bedside sleeper mode.
V. MAINTENANCE
• The mattress cover and fabric lining are removable and washable.
• Disassembly and assembly of this product can only be completed by adults.
• Please take care not to damage this product during disassembly and assembly.
• If there is any damage to the components of this product, please do not use this product again, and place this product away from children.
• When washing mattress cover and fabric lining, do not use dissolvable and corrosive articles.
• Please wipe bed with a sofr, dry cloth or sponge, not available with alkaline or acidic water to wash iron pipe or other tings.
• The brush is allowed to use when cleaning the mattress.
ENGLISH