Configuration (Standalone); Sound-Active Mode; Automatic Mode; Speed Adjustment - Chauvet DJ Beamer 6 FX Manual Del Usuario

Configuration Set the product in one of the Standalone modes to control without a DMX controller.
Connect the product to a suitable power outlet.
(Standalone)
Never connect a product that is operating in any Standalone mode (Static, Automatic, or
Sound) to a DMX string connected to a DMX controller. Products in Standalone mode may
transmit DMX signals that could interfere with the DMX signals from the controller.
To enable the Sound-Active mode, do the following:
Sound-Active
1.
Mode
2.
3.
4.
5.
The product will only respond to low frequencies of music (bass and drums).
The product will blackout when in Sound-Active mode after 3 seconds of silence or noise
below the sensitivity setting.
To enable the Automatic mode, follow the instructions below:

Automatic Mode

1.
2.
3.
4.
Speed To change the speed of Auto or Sound-Active mode, follow the instructions below:
1.
Adjustment
2.
3.
4.
Page 20 of 112
All manuals and user guides at all-guides.com
Press <MENU> repeatedly until SNDshows on the display.
Press <ENTER> and SN1–SN10 will show on the display.
Use <UP> or <DOWN> to select the desired Sound-Active program.
Press <ENTER>.
Turn the music on and adjust the sound sensitivity knob until the product starts responding to
the beat of the music.
Press <MENU> repeatedly until P-- shows on the display.
Press <ENTER> and P 1–P 10 will show on the display.
Use <UP> or <DOWN> to select the desired Auto program.
Press <ENTER>.
Press <MENU> repeatedly until S-- shows on the display.
Press <ENTER> and S.01–S.99 will show on the display.
Use <UP> or <DOWN> to adjust the program speed.
Press <ENTER>.
Beamer 6 FX User Manual Rev. 3