Other Operations - Sony MHC-DP1000D Manual De Instrucciones

Playing a disc (continued)

Other operations

To
Stop playback
Pause playback
Select a track or
chapter
Find a point in
a track title or
chapter
(Lock
Search function)
Change the
playback speed
(Slow-motion play)
Playing the disc
frame by frame
changing the
playback speed
(Freeze Frame)
Select a disc when
playback is stopped
Switch to DVD
function from
another source
Exchange other
discs during
playback
Remove the disc
GB
24
Do this
Press x. The playback stops at
the point x is pressed (Resume
Play). Press x again to cancel
the Resume Play (see page 28).
Press X *1
.
Press again to resume playback.
During playback or pause, press
> (or NEXT on the remote)
(to go forward) or . (or
PREV on the remote) (to go
back).
Press M or m during
playback. Each time you press
the button, the speed changes as
follows:
1 (slow) y 2 (faster than 1)
Press nN to stop searching at
the desired point.
During playback, press SLOW
*2 t or T *3
on the remote. Each
time you press the button, the
speed switches between two
slowed playback speeds. To
return to normal playback, press
nN.
During playback, press STEP
c or C *3
on the remote.
Each time you press the button,
*2
playback is advanced a single
frame in the desired direction.
To return to normal playback,
press nN.
Press one of the DISC 1–3
buttons or DISC SKIP EX-
CHANGE (or D.SKIP on the
remote).
Press one of the DISC 1–3
buttons (Automatic Source
Selection).
Press DISC SKIP
EX-CHANGE.
Press Z OPEN/CLOSE.
*1
There may be some disturbance in the video
image.
*2
DVD and VIDEO CD only.
*3 SLOW t and STEP c are not available during
playback of VIDEO CDs.
Tips
• You can use the digipad for DVD/VIDEO CD/CD
operations.
• You can use the digipad instead of cursor buttons
(v/V/b/B) when DVD is selected as the current
function and OSD appears on the screen.
Notes
• Depending on the DVD or VIDEO CD, some
operations may be prohibited.
• VIDEO CDs cannot be viewed slowly or frame by
frame in the reverse direction.
• Under the following circumstances, 2CH/MULTI is
automatically set to "2CH".
– When recording.
– When TAPE B is in REC PAUSE mode.
– When recording using TAPE B.
• When using headphones, the sound from
headphones is 2 channel.
• Switch the channel mode to "2CH" by pressing
2CH/MULTI when making an analog recording
using a component connected to the MD OUT jacks
on this unit. There is no audio output from the MD
OUT jacks in the multi channel mode.
• Depending on the DVD, digital recording may not
be done. In this case, perform analog recording.
Press 2CH/MULTI to switch the channel mode to
"2CH" on this system when making an analog
recording.
• Set the sound to "STEREO" using the AUDIO
button when you play DTS sound tracks on a CD
(page 32).