Technical Data - Davin DV Serie Manual

1.0 GENERAL
The DV switchbox is a time controlled relay box
that, depending on the model, can be used to
switch a maximum of 1 x 250W fitting, 1 x 400W
fitting, 1 x 600W fitting, or 1 x 1000W fitting.
Check the packaging to determine which of
the four models applies to you and locate
the relevant technical data in the table in 1.1

TECHNICAL DATA.

1.1 TECHNICAL DATA
Dimensions
Supply voltage
Max. Output
Thermal fuse
Number of power
outlets (wall sockets)
Insulation level
Dimensions
Supply voltage
Max. Output
Thermal fuse
Number of power
oulets (wall sockets)
Insulation level
1.2 REQUIRED (SUPPLY) VOLTAGE FOR DV
SWITCHBOX
When connecting the DV switch box, it is
preferable if you use a 'clean' group. A 'clean'
group means that the group is used exclusively
by the DV switchbox.
DV250W_DV400W_DV600W_DV1000W_Binnenwerk.indd 5
All manuals and user guides at all-guides.com
Manual DV - 250W/DV - 400W/
DV - 600W/DV - 1000W
250W 400W
170 x 137 x 95mm
230V AC / 50Hz
2A 3A
6A
1
IP-44
600W 1000W
170 x 137 x 95mm
230V AC / 50Hz
4A 5A
6A 15A
1
IP-44
If you do not have a (spare) 'clean' group, we
advise you to have a new 'clean' group installed
by a certified installer.
The DV switchbox contains a built-in (thermal)
fuse (for the rating of this fuse, see the table in
1.1 TECHNICAL DATA).
This fuse switches the DV switchbox off
automatically in the event that it is overloaded or
short ciruits.
1.3 INSTALLING THE DV SWITCHBOX
The rear of the DV switchbox features 2
brackets. You can use these brackets to install
the DV switchbox on a (flat) surface.
CAUTION!
The analogue timer switch is a sensitive
component in the DV switchbox and should not
be subjected to hard shocks.
• Install the DV switchbox somewhere near to
your 'clean' group.
On the underside of the DV switchbox, you will
find an earthed (230V AC) power cable.
• If necessary, fit an earthed power outlet to
your 'clean' group.
• Insert the plug on the power cable into the
power outlet of your 'clean' group.
• Your DV switchbox is now connected to the
mains voltage.
1.4 CONNECTING A FITTING TO THE DV
SWITCHBOX
You can connect a maximum of 1 fitting to
your DV switchbox. The connected load of this
fitting is dependent on which model you have
purchased.
In steps 1.2 and 1.3, the DV switchbox has been:
• Connected to a 'clean' group
• Installed on a (flat) surface
• Connected to the mains voltage
7
21-12-2011 22:43:38