Tabla de contenido
Idiomas disponibles
Idiomas disponibles
1
For ground connection, attach the
preinstalled green ground wire on
the light to the housing, using 1 of 3
connection methods:
#1
i.
Use sheet metal screw (B) to attach
to 1 of 3 slots inside housing.
ii.
Drive pan head screw (C) into
existing hole inside the housing.
Note: If no hole exists, drill a
small [1/8"] pilot hole and use the
#3
provided #8 sheet metal screw (B).
iii. Twist nut (D) onto the threaded stud
in housing wall.
2
Screw the Socket Adapter (B) into the
housing. Skip this step if the housing is already
equipped with an orange quick connector.
5
Press both pairs of torsion spring
legs together and insert them into the
receivers inside the housing.
Note: For easiest installation, insert
#2
both sides of the torsion springs
simultaneously (versus one at a time).
ONLY DO THIS STEP IF YOU ARE UNABLE TO REMOVE THE DEVICE USING THE APP .
If removal does not work, delete it in the app by clicking "my device is broken" and then follow the factory reset steps:
Using either a standard ON/OFF switch, circuit breaker, or the air gap switch on an Accessory Dimmer to cycle power -repeat
this pattern 4 times.
•
Repeat this pattern 4 times:
• Turn OFF for 2 second
• Turn ON for 5 seconds
•
After a brief delay, the Speaker Downlight will:
• flash twice and change to its default soft white (3000K) color temp to indicate a successful reset
• the small LED indicator will stay ON for approximately 10-second
INSTALLATIONS INSTRUCTIONS & MOUNTING
#3
#2
3
Plug the orange quick connect into
the light.
6
Using your smartphone/tablet, follow
the online Quick Start Guide to pair
the Speaker Downlight to your HALO
Home account. BringHaloHome.com
#3
FACTORY RESET
Cooper Lighting Solutions
1121 Highway 74 South
Peachtree City, GA 30269
P: 770-486-4800
www.cooperlighting.com
#2
4
Torsion Springs Removal
1.
2.
3.
#3
© 2020 Cooper Lighting Solutions
All Rights Reserved.
Specifications and dimensions
subject to change without notice.
Skip this step if installing into 6"
housing. For 5" housings: Loosen
screws on top brackets and slide
them into the 5" position & retighten
the screws.
UNINSTALLING
Pull down firmly on the module
until it stops.
Reach between the flange of the
light (inside the can) and squeeze
legs together to remove the fixture.
Unplug the orange connector and
remove the ground wire.
December 1, 2020 1:00 PM
IL518126ML
Tabla de contenido
