Idiomas disponibles
Idiomas disponibles
Instructions for use Multiplex Trio drain / overflow Visign MT3 / MT5
GB
E
Assembly steps
Mount seal. With steel
bathtubs with wall thick-
ness d
max
both seals.
Push the sleeve onto the
overflow pipe until the
lower edge is flush with
the edge of the overflow
pipe.
Bowden wire length
560 mm, 725mm:
Mount overflow pipe. If
necessary, shorten. The
overflow pipe must be
inserted at least 15 mm
into the connection.
Bowden wire length
560mm, 725mm:
The pipe must be
inserted at least 15 mm
into the sleeve and the
drain casing.
Push sliding ring and
seal ring onto the
drainage elbow. Screw
the drainage elbow onto
the odour trap using the
union nut.
p Align the odour trap and
connect to the waste-
water system.
Push the inlet piece into
≤ 3 mm mount
Insert the valve top and
Bowden wire length
Bowden wire length
Connect the water
q Check the drain fitting
the overflow unit.
the fastening screw and
tighten using the tool
supplied. The cross-
shaped structure of the
odour trap and the valve
top must be positioned
on top of each other.
1070 mm:
Mount overflow pipe. If
necessary, shorten. The
overflow pipe must be
inserted at least 15 mm
into the connection.
1070mm:
The pipes must be
inserted at least 15 mm
into the sleeve and the
drain casing.
inlet to the connecting
adapter.
for leaks after assembly.
38
Screw the fastening
screws in hand tight.
Caution: On the
hexagon of the fastening
aid (included in the
scope of delivery), there
is a groove, which must
be positioned on the lip
on the screw.
Place the profile seal
onto the drain in such
a way that the gap is
positioned over the
connecting pipe. Pull
the edge of the double
seal over the edge of the
drain.
Bowden wire length
560mm, 725mm,
1070mm:
Push the top end of the
overflow pipe into the
sleeve.
Push the union nut, seal
ring and wedge seal
onto the bottom end
of the drain elbow and
screw tight.
Cut the drain elbow if
the wastewater pipe
should only have a
diameter of 40 mm.
Insert the connecting
adapter with the
mounted water inlet all
the way into the over-
flow fitting until it makes
a clicking noise.
