Installation Location; Safety Instructions And Regulations - Vaillant 0020064070 Manual Del Usuario

1 Notes on the documentation

2 Safety instructions and regulations

3 Installation location

1 Notes on the documentation
We accept no liability for damage caused by a failure
to observe these instructions.
Auxiliary service equipment
Installation instructions geoTHERM VWS
Instructions for use geoTHERM VWL
All manuals of accessories and control units installed in
the heating system.
Applicability of the manual
These installation instructions apply exclusively to
appliances with the following part numbers:
Appliance type
VWS 61/2 230 V
VWS 81/2 230 V
VWS 101/2 230 V
VWS 63/2 230 V
VWS 83/2 230 V
VWS 103/2 230 V
VWL 71 230 V
VWL 91 230 V
Tab. 1.1: Part numbers of the appliances and the corresponding
accessories
The part number of the appliance can be found on the
identification plate.
a Warning !
To ensure all the functions of your Vaillant
appliance on a continuing basis and in order not
to change the approved original condition, only
original Vaillant replacement parts may be used
for service and maintenance work!
Information can be obtained from Vaillant
Customer Service Centres.
2 Safety instructions and regulations
The inrush current limiter may only be installed by a
competent qualified person registered with Corgi.
To ensure the safe installation of your appliance, the
laws, regulations, technical rules and standards
pertaining to the installation must be considered and
adhered to.
e Danger !
Danger of death from electric shock! The supply
terminals in the terminal box of the device are
under voltage even if the mains switch is off.
Before working on the appliance, turn off the
power supply
12
Part number of Part number of
the appliance the accessories
0010005501 0020064070
0010005502 0020064070
0010005503 0020064070
0010005504 0020064070
0010005505 0020064070
0010005506 0020064070
0010005694 0020064070
0010005695 0020066204
3 Installation location
3.1 For VWS 61/2, 81/2, 101/2 230 V
The inrush current limiter is located under the installati-
on panel (1) in the electronics box.
Fig. 3.1 Installation location of the inrush current limiter
(for VWS 61/2, 81/2, 101/2 230 V)
3.2 For VWS 63/2, 83/2, 103/2 230 V and VWL 71,
VWL 91 230 V
The inrush current limiter is located on the installation
panel (1) in the electronics box.
Fig. 3.2 Installation location of the inrush current limiter
(for VWS 63/2, 83/2, 103/2 230 V)
Installation instructions - Inrush current limiter for VWS/VWL
1
1