Ac Current Measurement - BGS technic 2203 Manual De Instrucciones

4.1 Accessories
Instruction manual
Test leads
Battery AAA 1.5V (x2)
Storage bag
5. Components
1 Transformer Jaws: Pick up the AC current flowing through the conductor.
2
Trigger: Press the lever to open the transformer jaws. When the lever is released, the jaws will close
again.
3 Data Hold Swith: A push switch (push on, do not pull to select function).All function and ranges with
this feature.
4 Rotary Switch: A rotary switch is used to select measurement Function and Range switch.
5 Display: 3½ digit (1999), decimal point, minus polarity, overrange and LO BAT indicators.
6 V. Ω. Input Connector: High input for all voltage, diode, continuity, measurement will accept banana
plugs.
7 COM Input Connector: Low input for all voltage resistance, diode, continuity, measurement, will accept
banana plugs.

5.1 AC Current Measurement

1. Make sure that "Data Hold" switch is not pressed.
2. Set the range switch to 2000mA, 20A, 200A or 600A
3. Press the trigger to open the transformer jaws and clamp one conductor only. It is impossible to
make measurements when two or three conductors are clamped at the same time.
4. Read the display
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Plug
Tel.: 02196 720480
Fax.: 02196 7204820
[email protected]
Electrical equipment
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed