LaserLiner 4K5 HD 1500 Manual De Instrucciones página 10

– To turn on lamp, short press power button
– When lamp is on, short press power button to switch from flood to spot mode, short press again to
turn off lamp.
– To activate stepless dimming when lamp is on, press and hold power button to adjust intensity (10%-100%),
the light source will flash once when either maximum or lowest intensity has been reached. If stepless
dimming was interrupted before maximum or minimum intensity is reached, activating stepless dimming
again will dim in the lamp in the opposite intensity level.
– To activate SOS function, when lamp is off, press and hold power button for 5 seconds.
– To activate HBS (human body sensor), when lamp is on, press HBS button
on the LCD display
for 15-30 seconds and will turn on lamp is any movement detected within 3-5 meters. Press the HBS
symbol again to turn off HBS function. Turning off the lamp via power button while the HBS is on will
also turn off the HBS.
– The OSS (Object Sensor System) will turn off light output whenever there is any obstruction in front of the
sensor, LCD display will remain lit so user knows light output was turned off due to OSS. If the
obstruction is removed, the light output will turn back on.
Diffuser
– Turn per below direction to lock in either Spot light
or Floodlight position
– Transforms a front facing floodlight to an all surrounding area light
Wide floodlight
angle of illumination
(without diffuser)
– To install the diffuser:
Insert and press down this part of diffuser into
corresponding slot
– To remove diffuser:
1 rotate the diffuser into this position
2 then pull out the diffuser in direction shown
10
EN
. HBS will turn off lamp if there is no movement beyond 3-5 meters around the lamp
All surrounding
area light with
diffuser on
.
. The HBS symbol will appear
1 2