Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Assembly
Release lashing belt at the feet, completely fold
■
out the tripod legs and position the tripod. In
doing so ensure that the guide of the stabiliser
bars [1] is pushed down to the stop.
Pull out the tripod feet (if necessary, allow for
■
the unevenness of the ground) and secure with
retaining screws [2].
■
Attention!
ALL the wing bolts must be securely
tightened!
Sequentially pull out the telescopic tubes until
■
they reach the desired length and TIGHTLY
secure with the corresponding wing bolt.
■
Attention!
Telescopic tubes can independently
retract under load if the wing bolts are
not fully tightened.
Secure the tripod using the supplied clamping
■
set above the clamping ring [3]
Attention!
The tripod must always be secured
using the anchoring ropes. Otherwise
there is a risk that the tripod will topple
over due to impacts, wind, etc.. Risk
of injury!
Use indoors, where stability is ensured
and there is no wind, represents a
special case.
When retracting the tripod, always:
Hold the tube to be retracted securely while
■
undoing the wing nuts and retracting the tube;
even with a slowly retracting tube there is a risk
of crushing.
When retracting do not remain under mounted
■
devices (e.g. when using a floodlight bridge).
As soon as the first tube is retracted, the
■
clamping set is no longer effective, bear this
in mind and if necessary take any appropriate
advance steps to secure the tripod during its
retraction.
Maintenance / care
Clean using stainless steel cleaning agent (item
■
no. 0893 121) and stainless steel preserving
oil (item no. 0893 121 0). Do not use any
technical solvents, acetone, benzene, tetra-
chloromethane, etc.
Likewise, do not leave in contact with oils or
■
grease for long periods.
Spare parts
If in spite of careful manufacturing and test proce-
dures, the device becomes faulty, a repair by Würth
masterService should be arranged. With any enqui-
ries or spare parts orders, always quote the article
number as given on the device type plate.
Warranty
We provide a warranty for this Würth device from
the date of purchase and in accordance with the
legal/country-specific regulations (proof of pur-
chase through invoice or delivery note).
Damage that has occurred will be corrected either
by replacement or by repair. Damage caused by
improper handling is not covered by the warranty.
Claims can only be acknowledged, if the device
is transferred fully non-disassembled to a Würth
agency, your Würth sales representative or a Würth
authorized customer service office. Subject to techni-
cal changes without prior notice.
We accept no liability for printing errors.
Environmental instructions
Do not throw the device away with
normal domestic waste. Dispose of
the device via an approved waste
disposal company or via your local
authority waste disposal facility.
Observe the currently valid regula-
tions. In case of doubt, contact your
waste disposal facility. Dispose of all packaging in
an environmentally compatible manner.
7
Tabla de contenido
