Installing The Magnetic Sensor For Horizontal Shaft Anchor Windlasses - MZ electronic EV-020 Instrucciones De Uso

Installing the magnetic sensor for vertical shaft anchor
windlasses
(see Fig. 1A – 1B)
•
Apply the drill template (see appended
instructions) and drill a 4 mm (~3/16") hole in
the cover through which to thread the sensor
cable.
•
Fasten Part A of the support with the two
screws provided, after having positioned the O-
ring in the lower part of the support.
•
Fit Part B with the magnetic sensor on support
A and adjust its height until it is aligned with the
magnet fastened on the gipsy.
•
Bring the sensor to a distance of about 3 mm
(~1/8") from the magnet and secure it in place
by tightening screw G1. Then tighten screw G2.
Installing the magnetic sensor for horizontal shaft
anchor windlasses
(see Fig. 2A – 2B – 2C)
•
Apply the drill template (see appended instructions) and
drill a 4 mm (~3/16") hole in the cover through which to
thread the sensor cable.
•
Fasten Part A of the support with the two screws
provided, after having positioned the O-ring in the lower
part of the support.
•
Cut Part C to measure using a hacksaw. The sensor
must be positioned at a distance of about 3 mm (~1/8")
from the magnet.
•
Fit Part C with the magnetic sensor on support A and fix it
in place using an adhesive for plastic (two-component
epoxy glue) or silicone.
•
Using the same glue, attach the sensor to Part C.
EV-020
G1
G2
29
English
B
A
OR
C
A
OR
Rev. 04 – 2007