Starting A Warmed-Up Engine; Stop Engine And Blade; Self-Propelled Mower - MADER TZ51SF-BS625EXi Manual De Instrucciones

4. The flywheel brake lever / operator's presence control / OPC handle is located in the upper handle of
the lawnmower. The handle must be depressed to allow the ignition and held against the upper handle.
5. The recoil starter handle is attached to the upper handle on the right-hand side. When starting,
always stand behind the lawnmower in the operating position. Pull the recoil starter handle until the
engine runs.
6. Once started, allow 2 / 3 minutes for the engine to warm up before mowing.
The blade starts to rotate after the engine is switched on.

Starting a warmed-up engine

B-
Move the throttle on «MIN» position
Depress the OPC handle to allow the ignition and held against the upper handle.
Pull the recoil starter handle until the engine runs.
Throttle Cable assy onto « STOP » position

Stop engine and blade

C-
Release the Operators Presence Control (OPC) handle to
stop the engine and blade.
The blade continues to rotate after the engine is
WARNING!!
switched off.
The OPC handle is a safety device.
WARNING!!
Never attempt to bypass its operations. The blade will be rotating when the engine is running
Once engine has been started, push the self-propelled

Self-propelled mower

D-
lever up against the upper handle and keep it in this
position.
The mower now starts to move.
To stop the mower, release the lever.
Move the
13