Nikon SUPER COOLSCAN 5000 ED Manual Del Usuario página 60

Inserting the Holder
1
Insert the MA-21 slide-mount adapter
After confi rming that the status LED is not blinking, slide
the MA-21 slide-mount adapter into the adapter slot
( 25). When the adapter is fully inserted, the status
LED will blink while the scanner initializes (
until the status LED stops blinking.
2
Insert the FH-3
The direction of insertion depends on which of the two
apertures in the metal cover contains the frame to be
scanned; refer to the illustration below (arrows indicate
direction of insertion). Slide the holder in until it stops.
To scan frames 1–3, insert the left end of
the holder into the scanner.
First frame
scanned (frame
"A").
Second
frame scanned
(frame "B").
Third frame
scanned (frame
"C").
Removing the Holder
After confi rming that the status LED is not blinking, remove
the FH-3 by hand. The eject button on the MA-21 can not
be used when removing the FH-3.
Remove Film Holders
Remove the FH-3 after use. Errors may occur if the FH-3 is in place when the scanner is turned on. If an
error occurs, turn the scanner off and then on again after removing the FH-3.
24). Wait
To scan frames 4–6, insert the right end of
the holder into the scanner.
Fourth frame scanned
(frame "D").
Fifth frame scanned
(frame "E").
Sixth frame scanned
(frame "F").
51